User manual HUSQVARNA 96043003304

[. . . ] YTH20K46 Owner's Manual / 96043003304 / 2009-05 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. WARNING: In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. WARNING: Do not coast down a hill in neutral, you may lose control of the tractor. WARNING: Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. [. . . ] NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth. • Remove blade bolt by turning counterclockwise. • Install new blade with stamped "GRASS SIDE" facing the ground. IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly. • Install and tighten blade bolt securely (45-55 Ft. IMPORTANT: Special blade bolt is heat treated. STAR BLADE BLADE BOLT (SPECIAL) CENTER HOLE 02 54 4 MANDREL ASSEMBLY Fig. 13 BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. • Keep battery and terminals clean. • Recharge at 6-10 amperes for 1 hour. NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary. 02828 CHECK REVERSE OPERATION (ROS) SYSTEM • When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine. • When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine. 15 MAINTENANCE TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. • Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. • Coat terminals with grease or petroleum jelly. • Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual). NOTE: Although multi-viscosity oils (5W30, 10W30 etc. ) improve starting in cold weather, they will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one year. [. . . ] 960 43 00-33 MOWER DECK KEY PART NO. 1 2 3 6 7 8 11 13 14 15 19 21 23 24 25 26 27 29 30 31 32 33 34 36 37 38 40 42 43 46 47 55 56 57 59 60 62 63 532 41 08-63 532 40 55-06 532 40 55-07 532 19 51-86 532 41 63-58 532 19 30-03 532 40 53-80 532 19 28-72 532 18 72-81 532 11 04-85 532 19 65-39 873 68 05-00 532 19 25-57 532 10 53-04 532 19 70-26 532 11 04-52 532 40 53-57 532 13 14-91 532 17 39-84 532 18 76-90 532 19 74-73 532 40 02-34 872 11 06-12 532 19 73-79 819 13 13-16 532 19 91-89 873 90 06-00 532 19 84-10 532 19 72-56 532 13 77-29 532 19 72-50 532 19 72-49 532 19 90-92 817 00 06-16 532 14 10-43 532 19 94-71 874 52 06-36 532 19 94-77 DESCRIPTION Mower Housing Cover Mandrel RH Cover Mandrel LH Arm Suspension Screw #10 x 0. 750 Bolt/Washer Asm 7/16-20 unf Blade Mower Shaft Assembly, Mandrel Housing, Mandrel Bearing, Ball, Mandrel Bolt, Shoulder Nut Bracket, Deflector Cap, Sleeve Spring, Torsion, Deflector Nut, Push Shield, Deflector Rod, Hinge Screw Thdrol Rolling Wsh Hd Washer, Spacer Pulley, Mandrel Nut, Toplock, Flanged Bolt Carr Sh. 5 Pulley, Idler, Flat Washer 13/32 x 13/16 x 16 Ga. 3/8-16 unc Spring Trosion Brake Spring Torsion Retainer Screw Bracket Clutch Cable Arm, Idler Spacer, Retainer Screw Hexwsh Thd 3/8-16 x 1 Guard, Tuv Idler (94) Arm Brake Mower LH Bolt 3/8-16 unc x 2-1/4 Gr. [. . . ]