User manual HUSQVARNA 96121000706

[. . . ] Thoroughly inspect the area where the equipment is to be used and remove all objects which may be thrown by the machine. - Refuel outdoors only and do not smoke while refueling. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot. - If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated. [. . . ] Stop the engine: - whenever you leave the lawnmower; - before refuelling. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. Check the grass catcher frequently for wear or deterioration. replace worn or damaged parts for safety. If the fuel tank has to be drained, this should be done outdoors. Manutenzione e Periodi di Inattivita’ • • 8 These symbols may appear on your machine or in the literature supplied with the product. 190 0– 4, 2 56 28 – 104 38, 6 9 3 9 1 8 4 2 7 6 5 10 ASSEMBLING Handle Pull up the handle in direction of the arrow. With the handle in up-turned position, tighten the wing-nuts. NOTE: The foot guard must be installed for the safe operation of this machine. PER LO SCARICO A TERRA - 12 Adjustment The handle can be set to different levels. Filling with Oil Fill the engine with engine oil. Fill the tank with petrol, not oil-blended. Both lead-free and lead-containing petrol may be used. Do not fill with petrol while the engine is running. €¢ Set the throttle to the “MAX” position. €¢ To start a cold engine, push primer three (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. €¢ Hold engine brake yoke to the handle and pull on starter handle quickly. [. . . ] Avoid filling with too much oil. Fitting and removing the blade require the use of protective gloves. Unscrew the cutter blade and deliver it to a service workshop for grinding and balancing. Tighten the screw properly when reassembling. [. . . ]