User manual HUSQVARNA 964004201

[. . . ] Always keep the lawnmower on the ground when mowing. Tilting or lifting the lawnmower may cause stones to be thrown out Keep bystanders away. Do not mow whilst people especially children or pets are in the mowing area Beware or severing toes or hands. Do not put hands or feet near a rotating blade. [. . . ] Locate the lower telescopic tubes (H1) inside the upper telescopic tubes (H2) and secure with the pin (H3) and retaining clip (H4) as illustrated in Fig H. Fit the Upper Handle to the Lower Handle by following the instructions above in ‘Assembly (without wheels)’ section. Handle Position The handle position can be adjusted using the guide and hook assembly. Thoroughly clean around the fuel tank filler cap before filling, this will help to prevent dirt being introduced into the fuel system. Fuel should be stored in a cool place away from naked flames. Do not fill the tank while the engine is running. Fill the fuel tank through a funnel fitted with a fine filter. Never fill fuel tank completely, only fill to the base of the filler neck. When filling the fuel tank from empty, or when the engine has previously run dry, a minimum of 400cc of fuel must be added (to the level of the line indicated in the diagram) to ensure correct priming of the fuel pump to start the engine. Fill with oil as instructed in your Engine Owners Manual provided with your product. Starting and Stopping To Start your Lawnmower 1. Adjusting the Cutting Height • • Never use more than 2 cutting height spacers. Spacers can only be fitted between the blade and the fan and never between blade and the bolt (P). Ensure the Operator Presence Control is released, when the engine has stopped rotating - disconnect the spark plug lead. Remove the blade bolt (P1) and blade (P2) as described in ʻRemoving the Blade and Fan’. Refit the blade as described in ʻFitting the Blade and Fan’. Removing & Fitting the Blade & Fan WARNING • Always handle the blade with care - sharp edges could cause injury. USE GLOVES • Spark plug lead may be hot - handle with care. Removing the Blade and Fan • Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. € If the blade is cracked or damaged replace it with a new one. Ensure the Operator Presence Control is released, when the engine has stopped and the blade has stopped rotating - disconnect the spark plug lead. Turn your lawnmower on its side with the air cleaner uppermost (see pic above). [. . . ] (e)The machine has not been serviced or repaired, taken apart or tampered with by any person not authorised by Husqvarna UK Ltd. (f)The machine has not been used for hire. (g)The machine is owned by the original purchaser. (h)The machine has not been used outside of the country for which it was specified. [. . . ]