User manual HUSQVARNA 966840301

[. . . ] SERVICE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTAINER CONTENTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 ASSEMBLY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] • Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision. CAUTION In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. CAUTION • DO NOT operate mower with grass catcher partially installed. • Disengage blades and stop engine before leaving mower seat to empty containers, unclogging chutes, etc. • Disengage mower blades when crossing driveways or gravel surfaces and other areas where thrown objects could be a hazard. • DO NOT attempt to vacuum up cans or other potentially hazardous projectiles. SERVICE • The operation of any mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your mower or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. - Never remove gas cap or add fuel with the engine running. - Allow engine to cool before refueling. - Never store the machine or fuel container inside where there is an open flame, such as a water heater. 2. Lift and rotate cover to align the frame bracket with the hanger and slide the cover down until secure. Cover Assembly Support Mount Hanger Bracket 3. Secure rear end of support straps to outside of hanger assembly. Set reinforcement plates to the outside of the tank brackets and fasten front end of support strap to tank bracket and reinforcment plate with round head bolt. Secure front end of reinforcement plate to tank bracket with hex bolt. NOTE: Depending on model, rear guard hole may need to be drilled out to 5/16" if kit hardware is too large. Hex Bolt Placement Round Head Bolt Placement Frame Bracket Hanger 3 INSTALLING SPACER PLUG Remove plastic end cap from the center bag support arm. Fully insert spacer plugs into the ends of the support tube. It may be necessary to tap the spacer into place with a hammer or mallet. Replace the plastic end cap back over the spacer. The additional extension will hold the hood more securely when latched. Reinforcement Plate Remove center Insert spacer and replace cap end cap Support Straps 8 ASSEMBLY 4 CONTAINER INSTALLATION 5 LOWER CHUTE INSTALLATION 1. Install containers on support frame, overlapping containers at center tube. Note: One container should always overlap the other container at the center tube. [. . . ] Normal wear, tear or abuse is not covered under warranty. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty. ****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months. Lifetime Warranty (Parts and Labor): All tiller tines and trimmer shafts against breakage. [. . . ]