User manual HUSQVARNA CT153

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment. â· Never allow children or people unfamiliar with the instructions to use the lawnmower. [. . . ] The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. The oil level in the engine should be checked before each run. The oil level should lie between the two markings on the oil stick. If more oil is needed add SAE 30 oil to the "FULL " marking. SAE 5W-30 oil should be used during the winter (below freezing point). The pressure in the front tire should be 1 bar (14 PSI) and 0. Ensure that the cutting unit is raised to the highest position and that the control for connection/disconnection of the cutting unit is in the disconnection position. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/disconnection control in position "connection". Your machine is also equipped with a system that will not allow mower to operate if the bagger or optional rear discharge deflector is not installed properly. Press down the clutch/brake pedal completely and hold down. Turn the ignition key to "START position". Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. Lower the cutting unit by moving the lever forwards. â· Retain the plug assembly by connecting the two straps into the holes provided on the bagger support arms. Insert the discharge chute into the opening in the backplate and onto the mower deck adaptor. Your tractor is equipped with a Dump Bag Alarm. Raise dump handle to its highest position. Pull handle forward to raise bagger and dump clippings. â· To continue mowing, be sure bagger is down and in proper operating position which will allow mower to operate. Do not drive in terrain at an angle of more than max. [. . . ] Engine and place the throttle lever in the Fast " IMPORTANT: Recheck the area making certain the area is clear. Remain in the operator's position with the cutting deck engaged until the deck is cleaned. Turn the ignition key to the STOP position to turn the tractor's engine off. Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle washout port. [. . . ]