User manual HUSQVARNA CULTIVATOR

[. . . ] OWNER/OPERATOR MANUAL Model: CT20 / 966957301 SPECIFICATIONS • Durable Tecumseh TC III Engine • Positive On/Off Switch • Heavy-Duty Handlebars with Anti-Vibe Grips • Depth Control Bar • Four Heavy-Duty Removable Tines • 6’’ or 10” Cultivating Width • Tine Speed—162 RPM • Worm Gear Drive • Approx. • Transport Kit Standard Equipment "TO TILL & CULTIVATE IN ROCKY SOIL CONDITIONS SEE PAGE 11 FOR ALTERNATE TINE ASSEMBLY" IMPORTANT! 505 29 00-57 04. 21. 08 CL PRINTED IN U. S. A. IMPORTANT MESSAGE TO THE CONSUMER AND/OR OPERATOR SAFETY SYMBOL This symbol of safety will be found throughout this manual alerting you to the possibility of injury. Don't expose yourself or others to danger. Carefully read each message that follows the safety symbol. SAFETY RULES AND PRECAUTIONS As with any item of power equipment it is necessary that you learn and observe ALL safety precautions. [. . . ] 9 Starter Cord Handle Location 8 b. Remove hairpin cotter and clevis pin from drag stake and adjust upward if unit is tilling too deeply. Adjust stake downward if more depth is necessary. Move switch to “I” position and restart engine to continue tilling. Fig. 11 TINE SPACERS The two tine spacers provided can be used to replace outside tines to narrow tilled path. Metal dust cap is held on with a set screw. Back set screw out approximately four turns. Dust cap should then slide off of the tine shaft. Remove air vent screw and fill hole screw from transmission. Fill transmission by using grease gun or grease applicator at the fill hole screw opening. Push gun or applicator against the opening so as to "seal" the nozzle of the gun or applicator against the casting embossment. Apply grease until you see the grease at the air vent hole. Re-install air vent screw and fill hole screw. Place a few drops of oil on tine shaft before installing tines. Re-install hairpin. DANGER! ALWAYS MOVE SWITCH TO "O" POSITION AND REMOVE SPARK PLUG WIRE BEFORE TRYING TO REMOVE OBSTRUCTIONS. CLEAN UNIT AFTER EACH OPERATION. * *ALWAYS CLEAN UNIT AFTER EACH OPERATION. This includes removing any string, wire, vegetation or other obstructions that have wrapped around the tine shaft. ADJUSTMENTS/MAINTENANCE LUBRICATION OF TRANSMISSION (See Fig. 12) (Transmission is pre-lubricated at the factory. ) Lubricate transmission after every 100 hours of use, if you see no grease at air vent hole. Replacement grease should be a high quality petroleum based grease usually available in disposable guns at most hardware or automotive parts stores. To lubricate transmission, proceed as follows: 1. Lay tiller on left side so that the tine shaft is vertical. Wearing heavy gloves, remove both right side tines. Remove dust cap. AIR FILTER NEVER RUN ENGINE WITHOUT COMPLETE AIR CLEANER INSTALLED ON ENGINE. Clean and re-oil every 3 months or every 25 operating hours, whichever comes first. [. . . ] Rental Warranty: 90 days on all applicable professional equipment reference warranty time period charts located in the back of the Retailer Warranty Policy & Procedure Manual. Husqvarna Safety Apparel carries a 90-day warranty from the date of the customer’s original purchase for defects in material and workmanship. Normal wear, tear or abuse is not covered under warranty. Product must be returned to Charlotte with a warranty claim form. [. . . ]