User manual HUSQVARNA DM S160

[. . . ] GB Operator's manual sure Please read the operator's manual carefully and make ES Manual de instrucciones You understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Approved protective helmet Approved hearing protection Protective goggles or a visor Breathing mask Make sure that the fork grips in the inner ear. [. . . ] The machine works at its best if not overloaded, let the maximum yellow LED on the load/power indicator (LCSLoad Control System) be on. Load the machine must then be run without a load for 2 minutes. The drill column can be variably adjusted through 360°. Drill holes (15 mm) in the floor or in the wall and knock in the expander bolts. Tighten the lock screw with an 8 mm allen key. The drill column can be turned through 360° and locked variably in each position using a locking screw (8 mm allen key) If the vacuum plate is used, make sure the support surface is not porous and can loosen from the floor or the wall. Make sure that the vacuum pump has sufficient power to secure the vacuum plate. The vacuum plate must never be used for ceiling drilling. Careless or incorrect use can result in serious or fatal injury to the operator or others. Column screw and lock screw Locking knob L-handle Drill column Column screw and lock screw Locking nut Drill motor DMS160 Place the base plate at a drill column's length from the wall. The support column screw should be screwed in. When drilling is to be performed at a height greater than 1. 5 metres, the heavier outer tube should be turned upwards and vice versa when drilling below 1. Check that the support column is clamped in the base plate with the locking screw. Clamp using the support column handle and screw the last bit using a 24 mm spanner. loosen the locking handle and rotate the drill column. Fold down the drill column using the L-handle. fit the drill motor DMS160 on the drill column. Then turn back the drill column with the drill motor to the desired position against the wall. Angle back and fold up the drill column, secure with the Lhandle and nut. When angle drilling, loosen the L-handle and set the drill column at the required angle by tightening the nut using a 30 mm spanner. Screw in the support column screw against the wall to secure the drill column. [. . . ] Check that the cord and extension cord are intact and in good condition. All types of repairs may only be carried out by authorised repairmen. This is so that the operators are not exposed to great risks. Remove the cover for the carbon brushes using a flat wide screwdriver. [. . . ]