User manual HUSQVARNA DUMP CART

[. . . ] 5 Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 iZ Models with Vertical Muffler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Front Weights iZ Models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] • Use care when approaching blind corners, shrubs, trees, or other objects that may obscure vision. 4 - Maintenance and Storage: • Stop engine and disconnect spark plug wire. Wait for all movement to stop before adjusting, cleaning, or repairing. • Clean grass and debris from muffler and engine to help prevent fires. • Let engine cool before storing and do not store near sparks or open flame. Do not store fuel near flames or drain indoors. • Never allow untrained personnel to service machine. • Keep hands and feet away from moving parts. If possible, do not make adjustments with the engine running. • Keep all parts in good working condition and all hardware tightened. Replace all worn or damaged decals. 6 ASSEMBLY Assembly Instructions For iZ Models with a Kawasaki engine and vertical muffer only. You must obtain a muffler kit Part No. Attach the backing plate and tube support to the hopper. iZ Models will use the front hole and the LZ Models will use the back hole. Connect the handle to the tube support using the pivot pin. Attach the threaded rod to the hopper and handle. When connected adjust the threaded tube using the adjusting nuts at both ends. The adjustment will be complete when the handle is pulled forward and the hopper door is fully closed. Adjust handle stop so it does not go over center. 2. 3. 4. HANDLE LZ MODELS HOLES PIVOT PIN iZ MODELS HOLES ROD END TUBE SUPPORT STOP ADJUSTMENT NUT TO HOPPER UNIT BACKING PLATE ADJUSTMENT NUT THREADED TUBE H O P P E R FRAME ROD END 12 ASSEMBLY HOPPER DOOR ADJUSTMENT Adjust door rods on both sides with adjusting nut so door closes evenly. See illustration. HOPPER HOPPER DOOR DOOR ROD ADJUSTMENT NUT DOOR ROD ADJUSTMENT NUT 13 ASSEMBLY Blower/Drive Kit 1. Open the drive kit box and remove all of the components. Place the deck in the lowest cutting height. [. . . ] For best results, clean poly mesh regularly. Release the two (2) rubber latches under the rear of the hood. Open hood and brush debris off of both sides. DO NOT USE THE COLLECTION SYSTEM WITHOUT POLY MESH SECURELY IN PLACE. 19 SERVICE AND MAINTENANCE Troubleshooting Guide DANGER Before servicing unit, wait for all moving parts to come to a complete stop. [. . . ]