User manual HUSQVARNA ELECTRIC DUMP SYSTEM KIT

[. . . ] remove the battery connector hardware using a 7/16" wrench and lift the battery out. CAUTION: To avoid arcing the battery, always remove the negative lead first before attempting to remove the positive lead. Remove the clip and clevis pin from the base of the dump handle and then remove the dump handle from the top of the bagger. [. . . ] Using the 2-3/8" clevis pin, install the actuator onto the lower bracket assembly with the motor facing towards the front of the tractor. Push a clip through the hole on the end of the 2-3/8" clevis pin. Using a 9/16" wrench and 9/16" socket, remove the bolt and nut that holds the bagger assembly support bracket to the bagger support frame. Install the lower bracket assembly onto the bagger support frame and align the mounting hole with the current hole in the frame. Install the 2 1/2" carriage bolt from the kit through the mounting hole, making sure to have the threaded end of the bolt facing towards the center line of the tractor. The support bracket that extends from the back plate should be installed between the frame and lower bracket assembly. Using a 9/16" socket, install a lock nut and washer provided in the kit on the 2 1/2" carriage bolt and tighten down. Pass the harness through the switch opening and then attach the new battery cover. Reaching into the bagger, connect the actuator to the upper pivot bracket assembly using the 1-3/4" clevis pin. Reach into the bag and use a clip provided in the kit to secure the 1-3/4" clevis pin. Use the switch to raise the bagger and then reattach the bagger mesh to the side of the bagger frame. NOTE: For tractors that have the factory equipped electric dump system, the ignition switch must be in the "ON" position for the bagger to dump. tractors retrofitted with the kit do not. WARNING: Keep fingers and objects clear of the bagger during operation. Press the switch down to extend the actuator fully while supporting the actuator with your right hand. CAUTION: Do not allow the actuator to press into the back plate. Your tractor is equipped with a Dump Bag Alarm. To dump clippings, activate the electric dump switch by turning the switch counterclockwise until bagger reaches its highest position. [. . . ] Déposez les boulons maintenant le support de réglage au tube de support et enlevez ensuite le support de pivot du support de réglage. À l'aide d'une clé de 9/16" et d'une douille de 9/16", enlevez le boulon et l'écrou qui maintient le support de l'ensacheur au châssis de support de l'ensacheur. Montez le support inférieur sur le châssis de support de l'ensacheur et alignez le trou de montage par rapport au trou dans le châssis. [. . . ]