User manual HUSQVARNA FS 6600 D

[. . . ] Operator's manual Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Husqvarna AB, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibility that the Husqvarna FS 6600 D, FS 8400 D dating from 2010 serial numbers and onwards (the year is clearly stated on the rating plate, followed by the serial number), complies with the requirements of the COUNCILíS DIRECTIVE: · DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO DO 8 Read this entire operator's manual before operating this machine. Keep all guards in place and in good condition. Wear safety approved hearing, eye, head and respiratory protection. [. . . ] The engine WILL NOT start unless the Speed Control Lever (1M) is in the STOP (1X) position. Check that the Transmission bypass valve (5L) is turned clockwise (DOWN) to the closed position. The Engine Throttle (1E) is at low idle speed setting. The glow plugs warm the engine for smoke freecold weather starting. Before starting up the machine, make sure you read this entire manual and are familiar with the operation of this machine. The working area must be completely clear, well lit and all safety hazards removed. The operator must wear protective clothing appropriate to the work he is doing. When message clears, Turn the Engine Start Switch (1C) to the "2" (START) position until the engine starts, then release the switch. If the engine does not start, turn keyswitch to "OFF" Position and repeat these steps. Push the Speed Control Lever (1M) forward for FORWARD saw movement, or to the rear for REVERSE saw movement. The further you push the lever the faster the speed. DO NOT OPEN the bypass valve (5L) to neutral while the saw is parked on a grade (or hill), The Operator will lose control and injury or damage could occur. Check that the engine oil level is correct. Engine often operates at an angle, check the oil level (with engine horizontal) frequently to ensure that the oil level never falls below the lower mark on the dipstick. Raise Machine to a high position using the raise/ lower switch (1N) on the Speed Control Lever (1M) Set the Engine Start Switch (1C) to the "0" (OFF) position. Install Outer Flange (2B) into the Blade Shaft (2I) making sure that the Locking Pin (2D) passes through the Diamond Blade (2E) and into the Inner Flange (2F). When moving the saw up and down ramps, with engine on, use extreme caution. To go UP a ramp, back the saw in REVERSE slowly. The saw can only be lifted by the factory installed Lifting Bail (6A). Block the saw in place or secure it into place using the factory installed TIE DOWN LUGS (3H), front and rear to prevent movement during transport. Make sure that the contact surfaces on the DIAMOND BLADE (2E), INNER & OUTER FLANGES (2B & 2F) and BLADE ARBOR (2C) are clean. Always use lockwasher(2J) with bladeshaft bolt (2A) · Install and tighten Blade Shaft Bolt (2A) and Lock washer (2J) using the Blade Shaft Wrench while firmly holding the Diamond Blade (2E). [. . . ] If gearbox seems hard to shift, a slight movement of the blade shaft may ease movement of GEARBOX SHIFT LEVER (3-2O) into proper gear. Never shift the Gearbox (3-2A) with engine running!Two Neutral positions are available in the Three Speed ENGINE GEARBOX (3-2A). This gearbox can be shifted into neutral if the blade rotation needs to be eliminated while the engine is running. [. . . ]