User manual HUSQVARNA FS 700 EX

[. . . ] Operator's manual Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The symbols below are used on the machine and in this Operator's Manual. It is important that the user understands the significance of these in order to work with the machine safely. Manual Please read the Operator's Manual carefully and understand the contents before the machine is started. [. . . ] Adjuster screw Adjust this screw to tension the drive belt. Hose holder The user can use the hose holder to prevent hoses and cables trailing behind the machine. These will lie to the side of the machine instead. Blade guard Can be fitted on either the right or left-hand side of the machine as required. The guard can be secured in the upright position by using the lever on the rear edge of the guard. Splash guard The machine is equipped with a folding splash guard to minimise water spray and dirtying. When the machine is transported over long distances the splash guard should be folded up and secured using the spring on the blade guard. The splash guard should always be folded down when cutting. Blade flange The blade flange fits on either side of the machine to allow the blade to be easily fitted on both sides of the machine The blade flange should be covered with the blade flange guard when a blade is not fitted The blade flange guard is fitted on the right-hand side on delivery. Fit the blade on the flush cutting blade flange when the cut is to be made next to a wall. A special flush cutting blade guard must be used when cutting flush. We recommend that Husqvarna W1100 series blades are used together with the machine Weight (excl. Speed drive shaft: ______________ 1780 rpm Periphery speed, saw blade ___________ 56 m/s Maximum blade diameter _____________ 725 mm max. NOTE When unsure about the significance of the technical specifications or when ordering spare parts please contact your dealer. Noise emissions (see note 1) Sound power level, measured dB(A) Sound power level, guaranteed dB(A) Sound levels (see note 2) Sound pressure level at the operators ear, dB(A) Vibration levels, ahv (see note 3) Handle right, m/s2 Handle left, m/s2 1, 3 1, 2 93 114 115 Under no circumstance may the machine be modified without written permission from Husqvarna Construction Products Sweden AB. Non approved modifications put you and others at risk of serious or fatal injuries. Husqvarna Construction Products Sweden AB bears no responsibility for operations or measures that do not follow these instructions. Note 1: Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive 2000/14/EC. note 2: Noise pressure level according to EN 13862. Reported data for noise pressure level has a typical statistical dispersion (standard deviation) of 1. Enclose the area to be cut so that unauthorised persons can not be injured or disturb the operator while working. Clearly mark out all cuts to be made on the floor before you start sawing, plan these so they can be carried out without danger to persons or the machine. [. . . ] Check the condition of the saw blade regularly for signs of wear or damage. When segments are worn or the width of the segments is nearly the same as the body of the blade, it should be replaced. Check regularly that electrical cables, couplings, drive belt and screw joints are not damaged. Check regularly that the drive belt and couplings are not dirty and that the drive belt is not tensioned too little or too much. [. . . ]