User manual HUSQVARNA HCLT130A

[. . . ] CAUTION: Always disconnect spark plug wire and place wire where it cannot contact spark plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. WARNING: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. SAFETY RULES • • • • • • • • • Stop the blade(s) when crossing gravel drives, walks, or roads. [. . . ] Hold operator presence control bar down to the handle and pull starter handle quickly. Do not allow starter rope to snap back. MULCHING MOWING TIPS IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS AND TRASH. SEE “CLEANING” IN THE MAINTENANCE SECTION OF THIS MANUAL. • 8 The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best recutting action of the blades. OPERATION • Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight. For best results, adjust the lawn mower cutting height so that the lawn mower cuts off only the top one-third of the grass blades (See Fig. If the lawn is overgrown it will be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of mulched grass. For extremely heavy mulching, reduce your width of cut by overlapping previously cut path and mow slowly. Using a blade not approved by the manufacturer of your mower is hazardous, could damage your mower and void your warranty. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. Make sure air filter and carburetor are up. Use a wood block between blade and mower housing to prevent blade from turning when removing blade bolt. NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth. Remove blade bolt by turning counter-clockwise. Remove blade and attaching hardware (bolt, lock washer and hardened washer). NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condition to work properly. Replace adapter if damaged. BLADE ADAPTER KEY CRANKSHAFT KEYWAY LUBRICATION CHART WHEEL ADJUSTER (ON EACH WHEEL) ➀ ➁ ENGINE OIL ➀ MULCHER DOOR HINGE PIN ➀ REAR DOOR HINGE ➀ HANDLE BRACKET MOUNTING PINS ➀ SPRAY LUBRICANT ➁ SEE “ENGINE” IN MAINTENANCE SECTION LAWN MOWER Always observe safety rules when performing any maintenance. BLADE LOCK WASHER TIRES • • Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber. Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. BLADE HARDENED BOLT WASHER TRAILING EDGE CRANKSHAFT BELT RETAINER FIG. [. . . ] The fit of the protective apparel/boot is not covered under warranty. ****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months. ¥ Effective manufacturing date 2/1/09. Units with serial number started 0905XXXXX or greater are affected. [. . . ]