User manual HUSQVARNA HCS 1372 COLLECTION SYSTEM

[. . . ] Collection System Operators Manual Parts Manual Models: 111750 / HCS1372 Please read these instructions carefully and make sure you understand them before using the machine. MANUAL NO. 539111758 REV 01 (03/31/05) ©2005 Husqvarna. Printed in U. S. A. 2 INDEX Operators Guide Features and Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Wait for all movement to stop before adjusting, cleaning, or repairing. • Clean grass and debris from muffler and engine to help prevent fires. • Let engine cool before storing and do not store near sparks or open flame. Do not store fuel near flames or drain indoors. • Never allow untrained personnel to service machine. • Keep hands and feet away from moving parts. If possible, do not make adjustments with the engine running. • Keep all parts in good working condition and all hardware tightened. Replace all worn or damaged decals. 6 ASSEMBLY Unpacking Instructions 1. Cut plastic tie securing the hitch to the crate top. Remove the mounting kit and drive kit boxs from the corner of the crate. Cut the two plastic ties that secure the hitch assembly to the pallet. Cut the two plastic ties that secure the back of the hood, and the two that secure the front of the hood. Cut and two plastic ties that secure the weight bar to the pallet. Cut the two plastic ties that secure the blower assembly to the pallet. Remove the 1 x 4 that secures the cast weights to the pallet. Remove the weights. Assembly Instructions Collection System Tools Required: Ratchet Torque Wrench 1/2" Wrench 1/2" Socket 9/16" Wrench 9/16" Socket 5/8" Socket (2) 3/4" Wrench 3/4" Socket Flat Screw Driver 1 2 FIGURE 1 1. Open the mounting kit box and remove all of the components. Place the support bracket on the frame and secure with (2) 990563, 3/8 x 1 bolts and (2) 976979, 3/8 nyloc nuts. Place the hitch brackets on the frame and secure with (3) 990622, 1/2 x 1 1/4 bolts and (3) 101331, 1/2 nyloc nuts. HITCH BRACKET 3. 7 ASSEMBLY 4. Remove the (10) 5/16 carriage bolts that secure the standard rear guard to the straps and skid plates. [. . . ] Rotate the blower around and into place. Install the pin thru the tabs on both the deck and the blower. Latch the idler arm in the idler keeper. Install the belt on the deck pulley and release the idler arm from the keeper. [. . . ]