User manual HUSQVARNA HE125A

[. . . ] Modifications to the unit may cause unsafe operations or damage the unit. When this product is worn out and no longer used, it should be returned to the reseller or other party for recycling. ©2010 HTC All rights reserved. Printed in U. S. A. Contents INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Driving and Transport on Public Roads. . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the engine does not start, wait about 10 seconds before retrying. 8050-006 Ignition switch 19 CONTROLS Choke Control The choke control is used for cold starts in order to provide the engine with a richer fuel mixture. For cold starts the throttle should be pushed forward to the choke position. WARNING!Observe caution and fill the tank outdoors (see the safety instruction). 8050-006 Choke control Refueling Read the safety instructions before refueling. The machine has one fuel tank, just behind the seat. The tank volume is 3 gallons (11. 4 liters). Make sure the fuel cap is properly tightened and the cap gasket is not damaged. The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See also Technical Data concerning ethanol fuel. Damage to engine and components may occur. IMPORTANT INFORMATION Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. In order to move unit under its own power, the operator must be in the seat, start engine (see Before Starting in Operation section), adjust engine speed to idle, disengage parking brake, do not engage blades at this time, rotate control levers inward. As long as the control levers have not been moved forward or backwards, mower will not move. Slowly move both control levers forward slightly. This will allow mower to start moving forward in a straight line. Pull back on control levers to the neutral position and mower should stop moving. Pull back slightly on control levers, this will allow mower to start moving backwards. Push forward on control levers to the neutral position and mower should stop moving. To turn to the right While moving in a forward direction, pull the right lever back towards the neutral position while maintaining the position of the left lever, this will slow the rotation of the right wheel and cause the machine to turn in that direction. To turn to the left While moving in a forward direction pull the left lever back towards the neutral position while maintaining the position of the right lever, this will slow the rotation of the left wheel and cause the machine to turn in that direction. To zero turn While moving in a forward direction, first pull both control levers back until the mower stops or slows dramatically. Then by alternating one lever slightly to the forward position and the other in the reverse position. Training Zero turn mowers are far more maneuverable than typical riding mowers due to their unique steering capabilities. [. . . ] Adjust the position of the steering controls. Fill with fuel and open the fuel shut off valve. Check that there is drive to both wheels. Check: The safety switch for the parking brake. [. . . ]