User manual HUSQVARNA HECTH135D

[. . . ] Visual check. Protective goggles or a visor must be worn. Refuelling. Both of the operator′s hands must be used to operate the chain saw. Never operate a chain saw holding it with one hand only. The chain brake must be engaged when the chain saw is started. Contact of the guide bar tip with any object must be avoided. Tip contact may cause the guide bar to move suddenly upward and backward (socalled kickback), which may cause serious injury. You will find the following labels on your chain saw: EPA II, CARB Other symbols/decals on the machine refer to special certification requirements for certain markets. Symbols in the operator’s manual: Switch off the engine before carrying out any checks or maintenance. The start/stop switch automatically returns to run position. In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance. [. . . ] 115 10 82-95 Rev. 2 2008-04-11 English – 21 STARTING AND STOPPING Note!Pull the front hand guard towards the front handle. • Always hold the saw with both hands. The right hand should be on the rear handle, and the left hand on the front handle. All people, whether right or left handed, should use this grip. Use a firm grip with thumbs and fingers encircling the chain saw handles. ! • WARNING!Long term inhalation of the engine’s exhaust fumes, chain oil mist and dust from sawdust can represent a health risk. Never start a chain saw unless the bar, chain and all covers are fitted correctly. See instructions under the heading Assembly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. • The chain brake is released by moving the front hand guard marked ”PULL BACK TO RESET” back, towards the front handle. Stopping • The chain brake should be activated when starting. Se instructions under the heading Start and stop. This method is very dangerous because you may lose control of the saw. Take great care when working on sloping ground. 3 10 Check the chain tension. General working instructions IMPORTANT!This section describes basic safety rules for using a chain saw. This information is never a substitute for professional skills and experience. If you get into a situation where you feel unsafe, stop and seek expert advice. Contact your chain saw dealer, service agent or an experienced chain saw user. Do not attempt any task that you are not sure you can handle!Before using a chain saw you must understand the effects of kickback and how to avoid them. See instructions under the heading How to avoid kickback. Before using a chain saw you must understand the difference between cutting with the top and bottom edges of the bar. See instructions under the headings How to avoid kickback and Machine’s safety equipment. See instructions under the heading Personal protective equipment. [. . . ] Move the chain saw at least 10 feet (3 m) from the fueling point before starting the engine. Do not allow other persons to be near the chain saw when starting or cutting with the chain saw. Keep bystanders and animals out of the work area. Do not start cutting until you have a clear work area, secure footing and a planned retreat path from the falling tree. [. . . ]