User manual HUSQVARNA HECTH151C

[. . . ] This manual contains proprietary information that is protected by copyright. No part of this manual may be photocopied, reproduced, or translated to another language without the written consent of Husqvarna. The information contained in this document is subject to change without notice. Husqvarna reserves the right to make design changes to vehicles without obligation to make these changes on units previously sold. [. . . ] Failure to heed this warning could cause the vehicle to overturn, possibly resulting in severe personal injury. • Reduce normal driving speed when transporting a vehicle on a trailer. • For use on public roads, the trailer must meet all federal, state, and local requirements such as taillights, brake lights, etc. • Never tow a Husqvarna vehicle behind a passenger vehicle or truck on a public road unless it is on an approved trailer. • The vehicle to be transported should be tied securely to the trailer, with the Forward/Reverse handle in the NEUTRAL position, the key switch in the OFF position, and the park brake firmly engaged. • Because of the added length of the trailer, use caution when making turns. • Do not transport the vehicle on a trailer with a load in the vehicle cargo bed. • Remove the vehicle windshield and secure the seats before transporting on a trailer. If the vehicle must be transported over long distances or on public highways, it should be transported on an approved trailer that has an approved load rating of 2000 lb. NOTE: A two-car trailer should be rated at 2 x 2000 lb. (2 x 908 kg = 1816 kg). 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 23 Storage STORAGE See General Warnings on page 9. DANGER • Do not attempt to drain fuel when the engine is hot or while it is running. Plug the fuel tank vent nipple so that it is air tight. We recommend using a slip-on vinyl cap. Page 24 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Storage 7. Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally starting. . . ” in General Warnings on page 9. Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3. 8 L) of water). Do not allow this solution to enter the batteries. Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03). 3 1 2 1. Open (ON) NOTE: When selecting valve position, ensure that it is fully opened or fully closed. 449 Figure 14 Fuel Shut-off Valve 9. To protect the engine, remove spark plug and pour 1/2 ounce (14. 2 mL) of SAE 10 weight oil into the engine through the spark plug hole. Rotate engine crankshaft by hand several times and then install the spark plug and tighten to 20 ft-lb (27 N·m). 10. Lower the passenger side seat and lower the cargo bed. [. . . ] Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. (3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions supplied is warranted for the period of time before the first scheduled replacement date for that part. If the part fails before the first scheduled replacement, the part will be repaired or replaced by Husqvarna according to subsection (4) below. Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. [. . . ]