User manual HUSQVARNA HELT130A

[. . . ] Modifications to the unit may cause unsafe operations or damage the unit. When this product is worn out and no longer used, it should be returned to the reseller or other party for recycling. ©2009 HTC. Printed in U. S. A. Contents INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Driving and Transport on Public Roads. . . . . . . . . . . . . . 5 Towing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Operating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Good Service. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Manufacturing Number. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 SYMBOLS AND DECALS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 . SAFETY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Safety Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Personal Safety Equipment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Slope Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Safe Handling of Gasoline. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Safe Handling of Propane. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 General Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Transport. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Rollover Protection System (ROPS). . . . . . . . . . . . . . . . . . 18 Spark Arresters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 CONTROLS. [. . . ] Do not tamper with the valves and fittings on the cylinder. 27 OPERATION Read the Safety Instructions section and the following pages if you are unfamiliar with the machine. will allow mower to start moving forward in a straight line. Pull back on control levers to the neutral position and mower should stop moving. Pull back slightly on control levers, this will allow mower to start moving backwards. Push forward on control levers to the neutral position and mower should stop moving. To turn to the right While moving in a forward direction, pull the right lever back towards the neutral position while maintaining the position of the left lever, this will slow the rotation of the right wheel and cause the machine to turn in that direction. To turn to the left While moving in a forward direction pull the left lever back towards the neutral position while maintaining the position of the right lever, this will slow the rotation of the left wheel and cause the machine to turn in that direction. To zero turn While moving in a forward direction, first pull both control levers back until the mower stops or slows dramatically. Then by alternating one lever slightly to the forward position and the other in the reverse position, the mower turns to the direction of the reverse position lever. Training Zero turn mowers are far more maneuverable than typical riding mowers due to their unique steering capabilities. We suggest that this section be reviewed in its entirety prior to attempting to move the mower under its own power. Additionally, we suggest when first operating the mower, use a reduced throttle speed and reduced ground speed by NOT moving control levers to the furthest forward or reverse positions during initial operation, or until operator becomes comfortable with controls. If it occurs, turn the ignition off and shut down the fuel valves. After a short interval, turn the fuel valves back on and repeat the start procedure. 8065-019 Turn to START position 10. When the engine starts, immediately release the ignition key back to the run position. IMPORTANT INFORMATION Do not run the starter for more than 5 seconds each time. If the engine does not start, wait about 10 seconds before retrying. 8061-001 Release ignition to the RUN position 32 OPERATION 11. Push the choke control in gradually when the engine has started. (Gasoline engines only. ) 8065-004 Push choke in after starting 12. Set the desired engine speed with the throttle. Allow the engine to run at a moderate speed, “half throttle”, for 3-5 minutes before loading it too heavily. USE FULL THROTTLE WHEN MOWING (no choke). WARNING!Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is an odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces. 8065-004 Set the engine speed 33 OPERATION Weak Battery WARNING!Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. [. . . ] Certificates can also be supplied with the machine at delivery or written in the Engine manual. Take care of them as they are valuable documents. CE requirements The Declaration of Conformity is included in the literature packet. 67 SERVICE JOURNAL Action Date, mtr reading, stamp, sign Delivery Service 1. Adjust the tire pressure of all wheels to 15 PSI (1 bar). [. . . ]