User manual HUSQVARNA HELTH125A

[. . . ] Always mix gas and oil in a clean container, never in the saw’s fuel tank. Shake the fuel mix before filling the fuel tank on the saw. O r f a o @ q q r p c a r d q q e r r c I i f c v c c a a m 3 m( f H m p A i d 1 t 11 S t c s t l a e r Before starting, check that the angle gear is sufficiently lubricated. This can be checked through the grease filler hole after removing the plug The gear housing should be filled with fresh grease, up to 3/4. [. . . ] Before refitting the spark plug, rotate the engine by pulling the starter handle, in order to “ventilate” the cylinder (the stop switch in position OFF). With an extremely hot engine, you may get vapour in the carburetor. In this case, use the starting procedure for cold engine. As a rule, three starting attempts are required. If at the fourth starting attempt the saw does not start, switch off the choke. Q Wrong fuel mixture (too much oil in the gasoline). Hard running conditions (such as cold weather). These factors cause deposits on the spark plug electrodes, which may result in malfunction and starting difficulties, If the engine is low on power, difficult to start or runs poorly at idling speed, always check the spark plug first. If the spark plug is dirty, clean it and check the electrode gap. The spark plug should be replaced efter about 100operation hours or earlier if the electrodes are badly eroded, CAUTION!Always use the recommended spark plug type. M @ m a W a r ao t a i u g n n n r l t g q Rinse the fuel tank with petrol. Q Clean the exterior of the carburetor and the space around it. Q Clean the fan and the space around it. Q Limpiar la rueda del ventiladory la zona alrededor @F A s a t s b a eg a a @ S R e S k a d F S S V R b V B F ac A a e d s d l l c i d e g r f @ y d l h c i p 5 i y A As a rule, filing should only be carried out on the front edge of the tooth. Check that the file holder is held firmly up against the rear edge of the tooth. File one tooth to the right and onetothe left, a J L U yu aI 24 S blade S S o t d s M a 5 2 A L t 5 h l l p M 2 4 M 2 A La pa a p d l h ac M - 2 c Das 4-zahnige Sageblatt wird mit einer Feile mit einfachem Hieb gefeilt. Lamea recommand6es: Maxi 200 (0 200 mm) Maxi 225 (0 225 mm) Multi 255(0 255 mm) r Maxi 200(0200 mm) Maxi 225(0225 mm) Multi 255 (0 255 mm) In the case of severe damage caused by cutting into a rock, it maybe necessary to adjust the top edge of the tooth with a flat file. This should be made before filing with the round file. Topedge filing must be equal on each tooth. €“ Adiust the set when the teeth have been field down to about half. Debera serde 1 mm ~ S s w m k e w c wa cc o s a ( l Su f - i c t h o e i f i ed Aer om h a e n i a q The clearing S;Woperator is responsible that nobody when clearing q Der Ftihrer des Freischneiders har dafiir zu sorgen, classihm beim q q q q q q q q comes closer than 10 m (30 ft). [. . . ] A saw with leaking fuel system must not be used. Do not start the engine where you have added fuel. Spilt fuel maybe ignited, Do not store the clearing saw and fuel in staff rooms. Use only containers approved for fuel storage. [. . . ]