User manual HUSQVARNA JET 46 R

[. . . ] Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. replace worn or damaged blades and bolts in sets to preserve balance. On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. [. . . ] Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade. Do not tilt the lawnmower when starting the engine or switching on the motor, except if the lawnmower has to be tilted for starting. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Do not start the engine when standing in front of the discharge chute. Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times. Never pick up or carry lawnmower while the engine is running. Stop the engine and disconnect the spark plug wire: - before cleaning blockages or unclogging chute; - before checking, cleaning or working on the lawnmower; - after striking a foreign object. Inspect the lawnmower for damage and make repairs before restarting and operating the lawnmower; - if the lawnmower starts to vibrate abnormally (check immediately). Stop the engine: - whenever you leave the lawnmower; - before refuelling. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. â· Place bracket on top of discharge guard, position bracket and guard on mower and secure with bolts and nuts supplied. NOTE: The foot guard must be installed for the safe operation of this machine. There are four (4) available heights of cut on your lawn mower. Fill the tank with petrol, not oil-blended. Both lead-free and lead-containing petrol may be used. Do not fill with petrol while the engine is running. To start a cold engine, push primer three (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. â· Hold engine brake yoke to the handle and pull on starter handle quickly. To "STOP" engine, release engine brake yoke. NOTE: In cooler weather it may be necessary to repeat priming steps. [. . . ] Mow slowly or mow the grass twice if it is very long. Always remove the spark plug lead before repair, cleaning or maintenance work. After 5 hours running time, tighten screws and nuts. The spark plug must be at the highest point on the mower when it is tilted up. [. . . ]