User manual HUSQVARNA K750 SPEEDMILL

[. . . ] Operator’s manual & spare parts list. t is the owner’s responsibility to ensure that all operators of this I machine have read and understood the content of this manual before using the product!Careless or improper use of this machine can cause serious or even fatal injury!Allow only competent adults to operate this machine! K 750 SpeedMill IPL, K750, 2007-01, 544 93 62-01 SpeedMill  TABLE OF CONTENTS Section Page No. [. . . ] Do not use when tired or under the influence of drugs, alcohol, or medication, or any substance that could affect your judgment. A moment of inattention during operation may result in serious personal injury. KEY TO SYMBOLS Use personal safety equipment. Always wear eye protection, hard hat, hearing protection, non-slip safety shoes and gloves. Respirator mask must be used when dry-cutting. (Reference OSHA 29CFR 1910. 95, 1910. 133-138) carefully Dress properly. Keep your hair, clothing, and gloves e away from the rotating blade. ine. The operator must wear protective clothing appropriate to the work he is doing. or s or fatal Keep proper footing and balance at all times. Do not overreach or operate from a ladder. Do not operate above Other use proper scaffolding to reach a safe operating chest height. If necessary symbols/decals on the machine refer to special height. certification requirements for certain markets. ng, this an haling lways Do not use the SpeedMill if the ON/OFF switch does not turn it on or off. Have the switch replaced before the SpeedMill is used again. WORK AREA SAFETY Keep the work area organized. Maintain a firm grip of the SpeedMill and have a proper footing and balance at all times. Do not operate your SpeedMill in an explosive atmosphere. Sparks may ignite flammable liquids, gases, or dust. This is a concern when old pipes are being repaired. Bystanders can be a distraction that can cause you to lose control. Use only 12” high speed abrasive concrete cutting blades for cutting specified PVC pipe with the SpeedMill. Use only blades designated High Speed blades with a minimum speed rating of 6300 rpm. Many blades are not made for hand held high speed saw and they all have a lower speed rating (marked on their label) Such blades might brake at higher speed with possible severe injury as a result. Diamond blades shall not be used while cutting any plastic pipe due to the increased risk of “kick-back”. [. . . ] Before using the assembled machine, completely read the power cutter operation manual supplied with this machine. Start machine per instructions in K750 Power Cutter Operation Manual. Position machine at top of plastic pipe to begin cutting through the pipe wall. Move saw forward while maintaining a “square cut” on the end of the pipe. This means the cut should always be perpendicular to the length of the pipe.  SpeedMill OPERATION Rotate Pipe and repeat this cutting process until pipe circumference is cut. Align proper SpeedMill Bowl with end of pipe, and move toward the pipe so that the pipe is slightly beveled. Note: The bevel required is usually quite small, so do not remove excessive pipe material. Bevel Pipe: Position SpeedMill Bowl near end of pipe to be beveled. [. . . ]