User manual HUSQVARNA LR 122

[. . . ] LR122 OWNER'S MANUAL SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. • • • • • • • • • • • • • • • GENERAL OPERATION Read, understand, and follow all instructions in the manual and on the machine before starting. Only allow responsible adults, who are familiar with the instructions, to operate the machine. Clear the area of objects such as rocks, toys, wire, etc. , which could be picked up and thrown by the blade. [. . . ] • Be sure that attachment clutch lever is in “DISENGAGED” position. • Lower mower deck to lowest cutting position. • Remove retainer spring and washer that holds mower clutch spring to the mower clutch arm. • Disconnect mower clutch spring from mower clutch arm. • Remove retainer springs and washers from mower stabilizer link. • Remove retainer springs and washers from rear lift links. • Remove retainer spring and washer from front lift link. • Withdraw front lift link, rear lift links and mower stabilizer link from brackets. • Raise mower lift handle to transport position. • Slide mower deck out on right side of tractor. MOWER UPSTOP ADJUSTMENT (See Fig. 19) • Raise attachment lift lever to highest (transport) position. • Measure distance from top of mower deck to lower flange of chassis (dim. “A” should be 3-3/8 to 3-1/2 inches. “A”, if required, lower mower to lowest position. Remove washer and retainer spring in trunnion, then withdraw trunnion pin from bracket. Loosen trunnion locknut and rotate trunnion counterclockwise on lift link to increase dim. “A” or clockwise on lift link to decrease dim. NOTE: Each full turn of trunnion will change dim. • Re-insert trunnion into bracket with pin pointing to L. H. • Raise lift lever to highest position and recheck dim. Repeat adjustment if necessary. LOWER FLANGE OF CHASSIS “A” TOP OF MOWER DECK TO INSTALL MOWER (See Fig. 18) • Reverse removal instructions. ENGINE PULLEY MOWER CLUTCH SPRING BELT MOWER CLUTCH ARM AXLE BRACKET RETAINER SPRING WASHER FRONT LIFT TRUNNION RETAINER SPRING WASHER BRACKET TRUNNION LOCKNUT FIG. [. . . ] This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty does not cover transmission units used for commercial purposes. LIMITED WARRANTY 46 WARRANTY STATEMENT SECTION 1: LIMITED WARRANTY Husqvarna Forest & Garden Company (“Husqvarna”) warrants Husqvarna product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the “Warranty Period” of the product as set forth below: Lifetime Warranty: All tiller tines, trimmer shafts, ignition coils and modules on hand held product. 2 Year Warranty: Riding lawn mowers, yard and garden tractors, walk behind mowers, tillers, trimmers, brushcutters, snow blowers, handheld blowers, hedge trimmers, and electrical products for noncommercial, nonprofessional, noninstitutional or nonincome producing use, except as herein stated. Emission control system components necessary to comply with CARB-95 and EPA regulations, except for those components which are part of engine systems manufactured by third party engine manufacturers for which the purchaser has received a separate warranty with product information supplied at time of purchase. [. . . ]