User manual HUSQVARNA LTH120

[. . . ] Local regulations may restrict the age of the operator. ⷠNever mow while people, especially children, or pets are nearby. ⷠKeep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. [. . . ] Full speed lies between these two positions. When the pedal is pushed down the brake is applied and the motor is disengaged. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Move the lever forward to connect the drive to the cutting unit, whereby the drive belt is tensioned and the blades begin to rotate. If the lever is moved backwards the drive will be disconnected and the rotation of the blades slowed down by the action of the brake shoes on the pulley. Quick lifting/lowering of the cutting unit Pull the lever backward to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backward (1). Push in the button (2) and then move the lever forward (3). There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. Start engine and move throttle control to slow position. Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. move motion control lever to neutral (N) position. Stop tractor by turning ignition key to "OFF" position. engage transmission by placing freewheel control in driving position. Start engine and move throttle control to slow position. Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times. Your tractor is now ready for normal operation. To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. [. . . ] blade Removal: · Raise mower to highest position to allow access to blades. Install new or resharpened blade with trailing edge up towards deck as shown. IMPORTANT:: To ensure proper assembly, center hole in blade must align with star on mandrel assembly. ⷠReassemble hex bolt, lock washer and flat washer in exact order as shown. [. . . ]