User manual HUSQVARNA R 52A

[. . . ] Tool safety Inspect the entire tool before each use. Check for fuel leaks and make sure all fasteners are in place and securely fastened. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. Pour fuel outdoors and where there are no sparks or flames. [. . . ] On models with open chute, never stick hand into chute. Never pick up or carry a mower while the engine is running. Stop the engine and disconnect the spark plug wire: before clearing blockages or unclogging chute; before checking, clearing or working on the mower. After striking a foreign object, inspect the mower for damage and make repairs before restarting and operating the mower. if mower starts to vibrate abnormally (check immediately). Stop the engine before you leave the mower: before refuelling. Maintenance - and storage safety Regularly check that all bolts, screws and nuts are tightened. Store tool and fuel in an area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. Allow the engine to cool before storing in any enclosure. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. Loosen the wire/cable from the handle before carefully folding the handle. Before public transporting engine oil and petrol must be removed. These symbols may appear on your machine or in the literature supplied with the product. TO ASSEMBLE & ATTACH GRASS CATCHER Put grass catcher frame into grass bag with stiff part of bag on the bottom. The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame. Do not drag the bag when emptying, it will cause unnecessary wear. The mower can be set to different cutting levels. Fill the tank with petrol, not oil-blended. Do not fill with petrol while the engine is running. To start a cold engine, push primer (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. â· Hold engine brake yoke to the handle and pull on starter handle quickly. [. . . ] After 5 hours running time, tighten screws and nuts. The spark plug must be at the highest point on the mower when it is tilted up. The level should be between FULL and ADD. Note: the dipstick must be screwed all the way down in order to indicate correct oil level. [. . . ]