User manual HUSQVARNA R148SV

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Anmält organ 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sverige, har utfärdat rapporter om bedömning av överensstämmelse enligt bilaga VI till RÅDETS DIREKTIV av den 8 maj 2000 angående emissioner av buller till omgivningen 2000/14/EG. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. [. . . ] Never refuel the machine while the engine is running. Always ensure there is adequate ventilation when refuelling and filling oil. Move the machine at least 3 m from the refuelling point before starting it. Never start the machine: 1 2 3 If you have spilt fuel or engine oil on the machine. Wipe off the spill and allow the remaining fuel to evaporate. If you spill fuel or engine oil on yourself or your clothes. Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and often brings added risks, such as icy ground. Make sure you can move and stand safely. Check the area around you for possible obstacles (roots, rocks, branches, ditches, etc. Take great care when working on sloping ground. The lawn mower should not be used on inclines greater than 30 degrees. The engine should be switched off when moving over ground that is not to be mowed. For example, gravel paths, stone, shingle, asphalt, etc. Never run with the machine when it is running. You should always walk with the lawn mower. Use extreme caution when reversing or pulling the lawnmower towards you. The brake handle must never be permanently anchored in handle when the machine is running. Shut down the engine before changing the cutting height. The cutting height can be adjusted in five different steps, mm. Follow the instructions above, but do not use a lawn mower in a situation where you cannot call for help in case of an accident. Do not set the cutting height too low as there is a risk that the cutters might hit slopes with unevenness. [. . . ] see instructions under the heading Assembly. If the cutter hits foreign objects such as stones, roots or the like the cutter will slip against the cutter bracket. This may mean that the contact surface of the cutter bracket appears slightly worn, which is completely normal. This is a safety device, which reduces the risk of the engine shaft becoming bent. [. . . ]