User manual HUSQVARNA T25 RS

[. . . ] For your own sake, we advise you not to alter the characteristics of your machine, and to use only the maker's recommended blades and accessories. Never let the cultivator be used by children, or by anyone unfamiliar with the instructions. There may be national laws which restrict the age of users. [. . . ] Work across the lie of the land, never uphill or downhill. When about to engage the blades, make sure there is nobody in front of or close to the cultivator. Hold the handlebar tight - it has a tendency to lift when the blades engage. While working, keep at a safe handlebar's length from the blades. Remove all stones, wire, glass, metal and loose objects from the area to be dug. When tilling stony ground, use low speed. Do not alter the adjustment of the motor's speed regulator; do not over-rev. Wear thick gloves when fitting or removing the blades. Work only in daylight or in good artificial light. Do not use the cultivator with worn or used parts. Spares of substandard quality may damage the machine and endanger your safety. To avoid fire risk, wait until the motor has cooled down before putting it away. Before putting the cultivator away remove any loose vegetation, especially around the motor once it has cooled. To reduce the risks of fire, keep the silencer and the area around the fuel tank free from leaves and oil. [. . . ] Every time you use the cultivator with an accessory, carefully read the fitting instructions and the user's manual provided. Ignition key DANGER DANGER Rotating blades WARNING Read the instruction manual WARNING - Consult the instruction manual and disconnect the spark plug before starting work. - Do not use without protective cover (rotating parts) Clutch lever Go Stop Stop Acoustic pressure level 1 2 3 4 5 6 7 - Circuit breaker - Silencer - Air filter - Petrol filter cap - Manual starter - Hand-grip - Oil gauge and filler cap - Clutch lever - Belt cover - Mudguard - Anchor tine - Rotary blades and plant protection disks 13 - Handlebars 8 9 10 11 12 A B C D E F G H I - Nominal power - Weight in kilograms - Serial number - Year of manufacture - Type of cultivator - Manufacturer's name and address - EC identifier - Maximum motor speed -Acoustic pressure level 1 Screws H M6x60 Z (4) 2 Flanged screws 6x16 Z (6) 3 Forged head bolt M8 (2) 4 Washer Ø8 5 Split washer 6 Z (4) 6 Plate washer Ø6 (4) 7 Bakelite nut (2) 8 Nut with collar 6 Z (10) 9 Cable clips (2) 10 Beta pin 5 Z (1) Do not block screws before assembly point 4 Block the screws after assembly point 4 - Place the switch (G), with the index towards the top, on the left-hand arm of the handlebars opposite the hole intended to fasten the switch. [. . . ]