User manual HUSQVARNA TS 1000 F

[. . . ] Safety goggles or eyeshade must be worn. " WASTE ELECTRICAL AND ELECTRNIC EQUIPEMENT (WEEE) " (2002/96/EC The obligatory technical regulations in force in the country where the machine is used must also be adhered to for maximum safety. Before leaving our factory every machine passes an exacting inspection programme in which everything is checked minutely. Following the instructions will ensure that your machine gives long service, in normal operating conditions. [. . . ] It is strictly forbidden to use the saw for any purpose other than that for which it has been designed. 1] at the front of the machine pivot with the locking system. 1] allow the machine to be moved with a forklift. rotate in the direction shown by the arrow on one of the sides. Make sure that the bearing surfaces of the disk, flanges and shaft are clean. For transport, lock the head as follows: · ⷠPosition the cutting head at the level for locking the transport screws (A) Using wrench (B), tighten the screws (A) until the casters are no longer n contact with the guide bars [FIG. Put back the tightening flange (C), Tighten nut (E), Put back and fasten disk cover Reconnect the water supply tube (F). For your safety and that of others, make sure that all guards are back in place before using. Always remain attentive Danger : risk of cuts To start using the machine, follow the transport procedure in reverse order. Before starting the machine, remove any wrenches or setting tools. Before handling the cut material in any way, stop the motor and wait for the disc to come to a full stop. Keep the safety guard in place for all work. Sound level at the workstation may exceed 85db (A) and therefore personal protection equipment must be worn. The machine is delivered with an uninstalled head advancement wheel (6) [FIG. 4] For start-up and after transport, the machine must be unbridled: · Loosen screws (A) until casters are in contact with the guide bars [FIG. Heat engine machines may not be operated in a confined space unless there is sufficient ventilation. the exhaust gasses contain carbon monoxide. Exposure to this toxic gas can cause loss of consciousness and death. (Water pump starts automatically with motor). Place the material on table (2) according to desired cut, using cutting guide (18) and rulers [FIG. [. . . ] In this case, please attach the bill of sale, as well as a report describing the problem encountered and asking that it be fixed under the terms of the guarantee. A technical diagnostic will be performed without delay on reception of the machine and you will be sent our conclusions. WARRANTY CONDITIONS To benefit the warranty, it is necessary to return the joined warranty certificate, duly completed, to Husqvarna within eight days of the purchase. In case of failure of the machine during the warranty period, our after-sales services will inform you of the appropriate and most effective method of dealing with your claim and advise you if necessary of your nearest approved service centre. [. . . ]