User manual HUSQVARNA TS350E-02

[. . . ] Information - Instruction: special instructions concerning use and inspection. The manufacturer declines any responsibility resulting from improper use, or modifications. It should be read and used by any person installing or using the machine. [. . . ] - Extension lead: Cable size sufficient for the electrical power, connection to the mains by a H07 RNF type cable of the following size: - 3 x 2. If the machine is fitted with a brake motor, do not use the quick-tightening nut. Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. Starting up Always pay extreme care and attention to the preparation of the machine before starting up Remove all adjustment tools and wrenches from floor and machine Always keep blade guard in place Electrical connection - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuit-breaker. Otherwise, consult our catalogue for appropriate models. - The RCCB must be used correctly, including testing it regularly. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. The water pump starting is coupled with that of the motor. As each machine is fitted with a self priming pump, the water is sprayed onto the disc as soon as the machine starts. - Make sure that the mains voltage corresponds with that marked on the manufacturer's plate on the machine. - Three-phase motor Make sure that the motor rotates in the same direction as the arrow stamped on the casing: if the motor does not turn in the direction required, swap two of the supply wires. Straight cuts (SEE FIG 14) 570 mm : the stop (C) prevents fingers being trapped between the table and the frame (SEE FIG 15). This cutting guide is machined in such a way that it can be fitted in several positions in addition to its right angle position from 0° to 45° to the left or to the right. - Make sure that the supply is correctly plugged in (plug, extension lead, etc) - Check the supply cable - Test or have tested by an electrician (circuit breaker, plug, etc) - Have tested by an electrician or contact the service department - Contact the service department to have the motor replaced - Have it checked by an electrician or contact the service department Drain the tank (22) frequently to remove cutting residue, which otherwise could block the pump and cause it to wear out prematurely. Swill out the tanks (1) and (22) with water. [. . . ] The manufacturer is not responsible for any direct or indirect, material or immaterial, damages caused to persons or things by failure of the machine or the non operation of the machine. WARRANTY CONDITIONS To benefit the warranty, it is necessary to return the joined warranty certificate, duly completed, to Husqvarna within eight days of the purchase. In case of failure of the machine during the warranty period, our after-sales services will inform you of the appropriate and most effective method of dealing with your claim and advise you if necessary of your nearest approved service centre. [. . . ]