User manual HUSQVARNA WR 360

[. . . ] Reserves the right to change specifications, equipment, or designs at any time without notice and without incurring obligation. Illustrations in this manual are merely for demonstration purposes and could not exactly match the detail described. No part of this manual can de reproduced without permission in writing of the copyright holder. All the motorcycles and their detailed parts taking part in competitions of any type are excluded from the guarantee. [. . . ] AIR FILTER CHECK Turn rear pin (1) anticlockwise, remove the saddle from the front fixing screw. AIR FILTER AND CLEANING Wash filter with gasoline and dry it fully. Plunge filter in special oil for filters, then wring it to drain superfluous oil. CAUTION*: Do not use gasoline or a low flash-point solvent to clean the element. CAUTION*: Clean the element in a well ventilated area, and do not allow sparks or flames anywhere near the working area. While re-inserting the filter into its housing, make surs that piece A is turned upwards and edge B is on the left lower side of the filter case. reassemble the parts previously removed (battery: connect the positive cable first). CAUTION*: If the element assembly is not installed correctly, dirt and dust may enter and the engine resulting in rapid wear of the piston rings and cylinder. NOTE (WR) When running on dusty roads clean the filter every 30 minutes. STEERING WHEEL BALL PLAY ADJUSTMENT To ensure maximum safety, the steering wheel should always be regulated so that the handlebars steering the motorcycle rotate freely without play. To check steering wheel adjustment, place kick stand or other support under the engine so that the front wheel is raised from ground. Place slight pressure on the tips of the handlebars to rotate steering wheel; the handlebars should also rotate without effort. Stand in front of the motorcycle and grasp the lower end of the fork rods sliders moving them in the direction of their axis. If play is noticed, proceed with adjustment as follows: - loosen steering sleeve nut (1); - loosen four screws that fix steering head to fork rods (3); - Turn the steering ring nut (2) clockwise of the steering sleeve proper tool, to adjust play properly; - tighten steering sleeve nut (1) to a torque setting of 57, 9÷ CAUTION*: Do not ride a motorcycle with damaged steering stem bearings. ADJUSTMENT OF THE LEVER FOR THE FRONT BRAKE FLUID LEVEL The driver will set the adjustment according to his needs. The level of the fluid in pump tank must never be below the minimum value (1), which can be seen from the window on the pump body. A decrease of the fuel level will let air into the sustem, hence an extension of the level stroke. WARNING*: If the brake lever feels mushy when it is applied, there may be air in the brake lines or the brake may be defective. Since it is dangerous to operate the motorcycle under such conditions, have the brake checked immediately by an authorized HUSQVARNA dealer. CAUTION*: Do not spill brake fluid on to any painted surface or lenses. CAUTION*:Do not mix two brands of fluid. Change the brake fluid in the brake line if you wish to switch to another fluid brand. [. . . ] - Empty the fuel from the fuel tank, and empty the carburetor float bowl. Avoid getting oil on rubber parts or in the brakes. - Set the motorcycle on a box or stand so that both wheels are raised off the ground. (If this cannot be done, put boards under the front and rear wheels to keep dampness away from the tire rubber). [. . . ]