User manual HUSTLER 107708

[. . . ] GENERAL INFORMATION This manual applies to the following Hustler equipment lines: Hustler Mini Z 36/42 Warranty registration The Delivery and Warranty Registration form must be completed and signed to validate your warranty protection. As the new equipment owner, you are expected to see that the form is completed and forwarded to Hustler Turf Equipment at time of delivery. Be sure to register the tractor plus each attachment that displays a model and serial identification number plate with Hustler Turf Equipment. IMPORTANT: Any unauthorized modification, alteration, or use of non-approved attachments voids the warranty and releases Hustler Turf Equipment from any liability arising from subsequent use of this equipment. To the new owner The purpose of this manual is to assist owners and operators in maintaining and operating the Hustler Mini Z tractor and deck. [. . . ] Place the control levers in the park brake position 2. Throttle back to low idle for a couple of minutes 4. Rotate ignition key counter-clockwise to the OFF position. Remove the key from switch before leaving the tractor. Operating suggestions DANGER: Prior to operating the tractor the operator should be thoroughly familiar with the proper use and operation of the equipment, should read the manual completely and thoroughly, and should have attempted slow moving maneuvers to become familiar with the operation of the equipment before attempting normal speed operation. An inexperienced operator should not mow on slopes or on uneven terrain. WARNING: If you lose steering control while operating the machine, place the steering control levers in the park brake position immediately. Inspect the machine and involve your Hustler dealer to resolve the problem before continuing to operate. WARNING: The unit's control levers are very responsive: Easy does it!For smooth operation, move lever slowly, avoid sudden movement. Skill and ease of operation come with practice and experience. Use caution when making turns and slow down before making sharp turns. Inexperienced operators may have a tendency to oversteer and lose control. Slow-moving practice maneuvers are recommended to become Moving tractor with stalled engine If it becomes necessary to move the tractor when the engine is inoperative, the transaxles are equipped with bypass valves. Before moving the unit, pull out on the bypass valve rods and slide them into the slot to lock in position. Both bypass valve rods are located underneath the rear of the tractor at the back of the transaxle. 3-5) The control levers must be placed in the neutral position, to release the park brakes, so that the tractor can be moved. Move it by hand or use a winch to load on a trailer for transporting. When transporting on another vehicle, the tractor must be secured. IMPORTANT: Always make certain the two bypass valves are returned to their operating position before running the tractor following repairs. WARNING: Allow engine exhaust manifold to cool before engaging or disengaging the bypass valves. The bypass valve rods are located close to the exhaust system. 12 107708_0306 FRONT OF TRACTOR FACES THIS DIRECTION N N FORWARD TRAVEL PIVOT TURN FORWARD TRAVEL RIGHT TURN REVERSE TRAVEL RIGHT TURN REVERSE TRAVEL N = Neutral Position Direction of arrows indicate direction of tractor movement. Figure 3-6 familiar with these characteristics before attempting normal speed operation. [. . . ] Store battery in a cool, dry place (do not expose to freezing temperatures) E. (Especially important to o prevent battery damage when the temperature is below 32 F. ) 8. Perform separate engine preparation as listed below. Drain fuel tank and run the engine until it stops from lack of fuel. [. . . ]