User manual HUSTLER 600643

[. . . ] GENERAL INFORMATION This manual applies to the following Hustler equipment lines: FasTrak 36/42 FasTrak 44/52 Warranty registration The Delivery and Warranty Registration form must be completed and signed to validate your warranty protection. As the new equipment owner, you are expected to see that the form is completed and forwarded to Hustler Turf Equipment at time of delivery. Be sure to register the tractor plus each attachment that displays a model and serial identification number plate with Hustler Turf Equipment. IMPORTANT: Any unauthorized modification, alteration, or use of non-approved attachments voids the warranty and releases Hustler Turf Equipment from any liability arising from subsequent use of this equipment. To the new owner The purpose of this manual is to assist owners and operators in maintaining and operating the FasTrak tractor and deck. [. . . ] If difficulty is encountered, contact the Hustler Dealer in your area. Before starting tractor each day, perform daily pre-operation checking. (See Safety start interlock system section) 2. Make sure the control levers are in the park brake position and deck clutch switch is disengaged. Use choke, if unit is equipped with one, when engine is cold, or if warm engine fails to start within 5 seconds of cranking. Avoid flooding and operate engine without choking as soon as possible. Set throttle at approximately 1/2 open position. Insert key in ignition switch and rotate full clockwise to engage starting motor. IMPORTANT: The engine starter should not be operated for periods longer than 30 seconds at a time. An interval of at least two minutes should be allowed between such cranking periods to protect the starter from overheating and burn-out. Perform test to make sure safety start interlock system is operating properly. Refer to Safety start interlock system section. As soon as engine begins to run, check to make certain the oil warning light, check engine light and alternator warning light (if applicable) are off. If not, stop engine immediately and check for the cause. Allow the engine to idle a few minutes before advancing the throttle and/or engaging the deck clutch. Before stopping the engine, place the control levers in the park brake Controls A. 3-2 & 3-3) -- these levers control the tractor's speed, direction, neutral lock, and park brake. Levers are used to steer, accelerate, decelerate and change direction. When the control levers are in the park brake position (3-3) the tractor will not move when the engine is on and drive pumps are operating. WARNING: The parking brake may not hold the tractor if parked on a slope. Block or chock the machine when parked on a slope B. 3-4) -- the deck lift pedal is used to raise or lower the deck. [. . . ] Store battery in a cool, dry place (do not expose to freezing temperatures) E. (Especially important to o prevent battery damage when the temperature is below 32 F. ) 7. Perform separate engine preparation as listed below. Drain fuel tank and run the engine until it stops from lack of fuel. [. . . ]