User manual HYOSUNG SF 50

[. . . ] IMPORTANT BREAK-IN INFORMATION FOR YOUR MOTORCYCLE The first 1, 000km(600miles) are the most important in the life of your motorcycle . Proper break-in operation during this time will help ensure maximum life and performance from your new motorcycle. Hyosung parts are manufactured of high quality materials, and manufactured parts are finished to close tolerances. Proper break-in operation allows the machined surfaces to polish each other and mate smoothly. [. . . ] the capacity is 4. 8) Fill the fuel tank before E. F KEY NITIO N G PUSH LOCK I (ON)POSITION The ignition circuit is completed and the engine can now be started. The key cannot be removed from the ignition switch in this position. (OFF) POSITION All electrical circuits are cut off. (LOCK) POSITION To lock the steering, turn the handlebar all the way to the left. Push down and turn key to the (LOCK) position and remove the key. All electrical circuits are disconnected. CAUTION The fuel gauge indicates the remaining amount whenever the ignition switch is (ON) or (OFF). For checking the remaining amount of fuel, put the motorcycles on the center-stand and set the ignition (ON). switch is TURN SIGNAL INDICATOR LIGHT When turn signals are being operated. OIL INDICATOR LIGHT When the engine oil level in the tank becomes too low requiring "HYPOL OIL" refilling. When the oil level check light turns on, the PUSH PUSH 7 G I NITI ON For preventing steal, Lock the steering. Turn the key from (OFF) to Pull out the key while from (Lock) to (OFF). HORN SWITCH CAUTION Check if the steering is locked. When it is not locked, Turn the handle right a little. LIGHT SWITCH TURN SIGNAL SWITCH LIGHT SWITCH TURN SIGNAL SWITCH " It is for left/right turning or changing lanes. " " position - for right turn signal " " position - for left turn signal " " Push the switch to cancel the operation. " position The headlamp, meter lamp and taillamp come on. " " position The headlamp, meter lamp and taillamp go off. CAUTION Turn off the lamp right after completing the turn or lane change. If you keep the lamp on, it could cause other drivers to be confused. HORN SWITCH 8 STARTER SWITCH 4. HOW TO USE HOW TO USE THE HELMET HOLDER When keep a helmet temporally, use the helmet holder following the illustration below. HELMET HOLDER STARTER SWITCH Push in the electric starter switch to rotate the starting motor. NOTE: If the front or rear brake lever is not squeezed, the starter motor will not rotate. CAUTION When the starter motor doesn'rotate within 5 t seconds after pushing the switch, try again after 10 seconds for preventing the damage on battery. HOW TO OPEN THE SEAT You can use the Trunk after opening the seat. 1) To unlock the seat, insert the ignition key into the lock and turn it counterclockwise. 2) To lock the seat, push clown firmly until the seat latch snaps into the locked position. 9 HOW TO USE THE PERSONAL TRUNK Keep the maintenance manual in the personal trunk. [. . . ] Take out air cleaner by disassembling 2 screws. Put out the filter. TIRES Check the tire pressure when it is cold. Tire Pressure Solo riding Dual riding Front 1. 25 kg/ 1. 75 kg/ Rear 2. 00 kg/ 2. 25 kg/ yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; yyyyyyyyy ;;;;;;;;; 21 CAUTION When the assembly of air cleaner filter is not completely done, dusts can go inside and damage severely engine. Be careful not to allow water to go into the filter while washing. ENGINE OIL AND GASOLINE Check if there is leakage around the oil pump and oil tank. BATTERY This motorcycle is equipped with sealed MF battery. Maintaining the battery does not need. CAUTION Don' take off the sealed cap. [. . . ]