User manual IBP MT301

[. . . ] Measure your blood pressure while sitting down / the measuring method / switching off . 13 the measured value memory / how to call up saved measured results / . How to quit the memory mode / deleting the memory contents . We are delighted that you have decided to purchase this blood sugar/pressure measuring system. [. . . ] This makes sure that you are able to carry out the test correctly, and that the device is working perfectly. If all three test results reach the value which is printed on the test strip container, you can start carrying out the actual blood sugar measurement. When should you carry out a test with the control solution?At least once per week when you open a new container of test strips if the measured results do not agree with the way you feel · if the device has been dropped · Every time when you suspect that the blood sugar measuring system is not working correctly Write the date of opening on the bottle. check the use-by date for the solution. Never use solutions past their use-by date. The control solution should reach room temperature (20°C to 25°C/68°F to 77 °F) before you use it. Shake the bottle of test solution well before you open it. Wipe the first drop away, and then use the second drop to ensure that you have a good sample for precise measure results. - You should use the control solution up within 90 days of opening. - Keep the solutions safely closed away at room temperature (below 30°C). If the control window is not completely filled with blood (Fig. 19) and the device starts the measuring process, do not apply more blood subsequently. Pull the test strip out to stop the test process. Start again from the beginning by feeding in a new test strip and applying the necessary blood drop. If you cannot manage to fill the test strip with enough blood, please contact our service department. Note: If you do not apply blood to the test strip within two minutes, the device will make a beep to tell you to turn it off by pulling out the test strip. Remove the strip, and then feed it into the device again to start the test procedure once more. After the device has finished the countdown (max. 10 sec) , the measured results are shown in the display. The blood sugar test measured values are automatically stored in the memory. To turn the device off, pull the test strip out. [. . . ] Replace both old batteries with new ones. Replace both old batteries with new ones. Replace both old batteries with new ones. Dubious measured results which deviate strongly from average values. [. . . ]