User manual ICEBERG FOOTSICLE

[. . . ] Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not expose batteries or apparatus with battery-installed to excessive heat such as sunshine, fire or the like. The unit is not disconnected from the mains as long as it is connected to the AC outlet, even if the unit itself has been turned off. [. . . ] , Make sure the PARTY host has permitted access from this unit. You cannot select the playback range or playback mode. , Only the playback range or playback modes supported by the currently active renderer (network controlled player) are displayed. You cannot return to the content list even if you tap . , The server list appears when you tap , depending on the content currently being played back. , Make sure the unit has registered the PARTY host in advance. You cannot find devices having the PARTY STREAMING function. , Check the following possible causes. · This unit is not registered with any devices having the PARTY STREAMING function. · Devices having the PARTY STREAMING function are not turned on. You cannot find a new renderer (network controlled player). , You can only register up to 30 devices. Delete any unnecessary devices, then tap " HOME screen. Refresh" on the , Make sure of the following. · Does the renderer (network controlled player) have access limitations even though you have not registered 30 devices yet?· Is the renderer (network controlled player) connected to your network correctly?· Is the renderer (network controlled player) function of the device active? You cannot start a PARTY with the desired content. , Start the PARTY after playing back the desired content using a device with the PARTY STREAMING function (page 38). Content stored on the server is not displayed on the content list. Too much light there can interfere with remote control operations. Be sure to place the unit out of the reach of small children or pets. Components such as air-conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused. Completely disconnect the power cord (mains lead) from the wall socket (mains) if it is not going to be used for an extended period of time. When unplugging the unit, always grip the plug. Should any solid object or liquid get into the unit, unplug the unit, and have it checked by qualified personnel before operating it again. The AC power adaptor can be changed only by a qualified service facility. On placement · Do not place the unit in an inclined position or in locations that are extremely hot, cold, dusty, dirty, humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. Be careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. On disposing of the remote control Before disposing of the remote control, the built-in battery should be removed for environmental protection. · Notes · · Do not remove the screws at the bottom of the remote control except when disposing of the remote control. Before removing the built-in battery, make sure it has completely drained. · About the AC power adaptor · Use the AC power adaptor supplied with this unit. Do not use any other AC power adaptor since it may cause this unit to malfunction. · Use the following procedure to remove the built-in battery. 1 · Remove the two screws on the bottom of the unit. Polarity of the plug · Connect the AC power adaptor or the power cord to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor or the power cord, disconnect it from the AC outlet immediately. [. . . ] 11. OpenCV Copyright (C) 2000-2008, Intel Corporation, all rights reserved. Copyright (C) 2008-2010, Willow Garage Inc. , all rights reserved. Third party copyrights are property of their respective owners. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: * Redistribution's of source code must retain the above copyright notice, this list of conditions and the following disclaimer. [. . . ]