User manual ICOM HM-157B-SW

[. . . ] INSTRUCTIONS REMOTE-CONTROL MICROPHONE Thank you for purchasing the HM-157 REMOTETM CONTROL MICROPHONE. The COMMANDMIC II is a remote control microphone for use with the IC-M602, M504, M422, M402 or else. Please read these instructions and transceiver's instruction manual carefully before installation and operation. HM-157 These instructions are described when the HM-157 is connected to the IC-M504. Some operations or indications may be different as these instructions depending on the connecting transceiver. /0 VOLUME/DIMMER/PA/RX SPEAKER KEY [VOL]( DIM PA/RX ) After pushing [ VOL ] , push [ Y ] or [ Z ] to adjust audio level. [. . . ] r Push [ Y ] or [ Z ] to select the desired channel. · When receiving a signal, " " appears and audio is emitted from the speaker. · Further adjustment of the audio level may be necessary. · Use the optional Voice scrambler function for privacy. Push for 1 sec. Calls the transceiver when pushed and held while in Intercom mode. While pushing [ H/L ] , activates an optional Voice scrambler* function. · The Voice scrambler function cannot be used on Ch 16 and 70. * The Voice scrambler function is available depends on the transceiver. . SQUELCH/MONITOR/LOCK KEY [ SQL ]( MONI L) After pushing [ SQL ] , push [ Y ] or [ Z ] to adjust noise squelch level. While pushing [ H/L ] , push [ SQL ]( MONI L) to toggle the (microphone) Key lock function ON or OFF. · "T" appears while Key lock function is in use. · [ PWR], [ PTT ] , [ VOL ] , [ SQL ] and [ H/L ] still function when PWR] the (microphone) Key lock function is turned ON. Push for 3 sec. to enter call channel programming condition when call channel is selected. While pushing [ H/L ] , enters channel comments programming condition. While turning power ON, push to enter Set mode. Advance the cursor while in channel comment programming condition. Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries. COMMANDMIC II is a trademark of Icom Incorporated (Japan) in the United states. o SCAN INDICATOR "SCAN" appears during Normal scan. "P SCAN" appears during Priority scan. !0 PRIORITY CHANNEL INDICATOR Indicates a priority channel during Priority scan or Dual/Triwatch. !1 DUAL/TRI WATCH INDICATOR "DUAL" appears during Dualwatch; "TRI" during Tri-watch. !2 WEATHER CHANNEL INDICATOR "WX" appears when a weather channel is selected. "WX ALT" appears when the Weather alert function is in use; blinks when an alert tone is received. !3 LOW POWER INDICATOR Appears when low power is selected. !4 CALL CHANNEL INDICATOR Appears when call channel is selected. !5 DUPLEX INDICATOR Appears when a duplex channel is selected. [. . . ] r Push [ 16 ]( 9 ) to select the desired item, if necessary. t Push [ Y ] /[ Z ] to select the desired condition of the item. y Turn power OFF, then ON to exit Set mode. · Beep tone You can select the silent operation or you can have confirmation beeps sound at the push of a key. ·" " appears at the channel comment indicator. Monitor function The monitor function releases the noise squelch mute of the microphone only. [. . . ]