User manual ICOM IC-27A-E

[. . . ] Keep the antenna at least 2. 5 centimeters (1 in. ) from your head and body. · If you wear a portable two-way radio on your body, ensure that the antenna is at least 2. 5 centimeters (1 in. ) from your body when transmitting. IMPORTANT R CAUTION!NEVER hold the transceiver so that the antenna is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 2 to 4 in. [. . . ] the BC-137 #02 The optional BC-137 #02 provides regular charging of optional battery pack with/ without transceiver. The following is additionally required: · An optional AC adapter. (A charger adapter is supplied with BC-137 #02. ) Check orientation for correct charging. (Insert together with charging adapter. ) BC-137 #02 8 BATTERY PACKS 3 ` Charging NOTE Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. · Recommended temperature range for charging: +10°C to +40°C (50°F to 140°F). · Use the supplied charger or optional charger (BC-119/BC-121 for rapid charging, BC-137 #02 for regular charging) only. NEVER use other manufacturers' chargers. The optional BP-209 or BP-210 battery packs include rechargeable Ni-Cd (Ni-MH: BP-210) batteries and can be charged approx. Charge the battery pack before first operating the transceiver or when the battery pack becomes exhausted. If you want to charge the battery pack more than 300 times, the following points should be observed: · Avoid over charging. The charging period should be less than 48 hours. · Use the battery until it becomes almost completely exhausted under normal conditions. Push and hold the [Emergency Single/Repeat] switch for 1 sec. to activate the emergency function. · The transceiver selects a pre-programmed channel, then sends an emergency signal to your Base Station. · The pre-programmed channel remains selected until a control signal is received from the Base Station, or power is turned OFF. · The emergency call is repeatedly transmitted at pre-programmed intervals. 14 PROGRAMMABLE FUNCTIONS 4 D DISPLAY LIGHTING The function display has 3 backlight conditions. AUTO : When any key, except [PTT], is pushed, the backlight turns ON for 5 sec. D SmarTrunk IITM functions This transceiver provides SmarTrunk IITM functions. (Optional UT-105 SmarTrunk II TM Logic Board is required. ) The optional UT-105 allows communication over conventional channels or SmarTrunk IITM channels. Select a channel bank for SmarTrunk IITM before trunking operation. To toggle SmarTrunk IITM channels and conventional channels, push the [Bank] switch one or more times. · Scanning starts when a channel bank for SmarTrunk IITM is selected. · Contact your dealer for channel bank details. 19 for more detailed operation. ) 15 5 CONVENTIONAL OPERATION ` Receiving and transmitting NOTE: Transmitting without an antenna may damage the transceiver. Receiving: q Push [CH Up]/[CH Down], or rotate the [SEL] to select a channel. [. . . ] Refer to the HELP file that comes with the CS-F30G CLONING SOFTWARE for available settings. 22 OPTIONAL UNIT INSTALLATION TM 8 You can install two of the following optional units in the transceiver. UT-105 SmarTrunk II Logic Board, UT-109/UT-110 VOICE SCRAMBLER UNIT, UT-111 TRUNKING BOARD, UT-113 MAN DOWN UNIT. ` Installation q Unscrew nut a, and remove the knobs. w Unscrew screw b, 2 screws c then remove multi-connector cover and rear panel. e Unscrew 2 screws d, then remove multi-connector. [. . . ]