User manual ICOM IC-2IA

[. . . ] The transceiver will perform best if the microphone is 2 to 4 in. (5 to 10 cm) away from the lips and the transceiver is vertical. NEVER operate the transceiver with a headset or other audio accessories at high volume levels. NEVER short the terminals of the battery pack. [. . . ] · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " Check orientation and Spacer B/C " pointing up. NOTE: Push the notch carefully when remove the spacer from the adapter. 8 3 BATTERY PACKS D Rapid charging with the BC-121N+AD-94 (#11) The optional BC-121N allows up to 6 battery packs to be charged simultaneously. The following are additionally required. · Six AD-94 (#11) (Some versions require additional AD-99s). · An AC adapter (may be supplied with the BC-121N depending on version). Turn power OFF. AC adaptor (purchased separately) AD-99 MULT I-CHA RGER Charge indicator (each indicator functions independently) D Regular charging with the BC-146 The optional BC-146 pro- Turn power OFF. vides regular charging of optional battery pack with/ without transceiver. The following is additionally required: · An optional AC adapter. (A charging spacer is supplied with BC-146. ) Check orientation for correct charging. (Insert together with charging adapter. ) BC-146 9 BATTERY PACKS 3 ` Charging NOTE Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. · Recommended temperature range for charging: +10°C to +40°C (50°F to 140°F). · Use the supplied charger or optional charger (BC-119N/BC121N/BC-144 for rapid charging, BC-146 for regular charging) only. NEVER use other manufacturers' chargers. Push the [Scan] switch to start/stop scan. · Scan pauses on a channel when receiving a signal. · "Lockout SCAN" (pre-programmed list SCAN) or "Priority SCAN" can be pre-programmed. · When the "Power-save function" is activated, the transceiver checks all pre-programmed channels then returns to the "Powersave function" again. D HIGH/LOW POWER OUTPUT This function selects high or low power for a channel. Push the [High/Low] switch to toggle between high and low power. 13 PROGRAMMABLE FUNCTIONS 4 D MONITOR AUDIBLE FUNCTION The monitor function allows you to open the transceiver's squelch manually to check whether a channel is busy or not. The transceiver has 2 conditions for receive standby: Audible condition: This condition mutes audio ONLY when no carrier is present. You can receive (or monitor) any signals on a channel. · Push and hold the [Moni], switch to select the audible condition. Any audio mute functions are cancelled while pushing the [Moni] switch. Inaudible condition: This condition mutes ALL signals except those directed to you. [. . . ] · BP-210 Ni-MH BATTERY PACK 7. 2 V/1650 mAh Ni-MH battery pack, allows approx. · BP-211 Li-Ion BATTERY PACK 7. 4 V/1800 mAh Li-Ion battery pack, allows approx. · BP-222 Ni-Cd BATTERY PACK 7. 2 V/600 mAh Ni-Cd battery pack, allows approx. 5. 5* hours operation (Same as supplied with 2 W models). [. . . ]