User manual ICOM IC-3AT

[. . . ] NEVER operate the transceiver with a EXPLICIT DEFINITIONS The explicit definitions below apply to this instruction manual. WORD R WARNING CAUTION NOTE DEFINITION Personal injury, fire hazard or electric shock may occur. No risk of personal injury, fire or electric shock. headset or other audio accessories at high volume levels. Hearing experts advise against continuous high volume operation. [. . . ] 16) Band edge Scan Jump Band edge Repeatedly scans all frequencies over the entire selected band. PROGRAMMED SCAN (p. 16) Band edge Scan edges Band edge Scan Jump Repeatedly scans between two user-programmed frequencies. Used for checking for frequencies within a specified range such as repeater output frequencies, etc. Repeatedly scans memory channels except skip channels within memory bank 0 (memory channels 0­99) or memory bank 1 (memory channels 100­199). MEMORY SKIP SCAN (p. 16) Repeatedly scans all memory channels except skip Not yet programmed channels. ch 1 ch 0 ch 199 ch 6 ch 5 ch 2 ch 3 ch 4 SKIP MEMORY BANK SCAN (p. 16) Not yet programmed ch 1 ch 0 ch 99 ch 6 ch 5 ch 2 ch 3 ch 4 FREQUENCY SKIP FUNCTION (p. 19) Band edge or scan edge Scan Skip Jump Skip Band edge or scan edge SKIP Skips unwanted frequencies that inconveniently stop scanning. This function can be turned ON and OFF in expanded set mode. 15 6 SCAN OPERATION s Full/band/programmed scan q Select VFO mode with [V/M]. w Make sure the squelch is set to the threshold point. · Select automatic squelch (AUTO) or a level (1­9) where the noise is muted. 10) s Memory (bank) scan q Select memory mode with [V/M]. w Make sure the squelch is set to the threshold point. · Select automatic squelch (AUTO) or a level (1­9) where the noise is muted. !0 Push [V/M] to exit set mode. 1 Memory channel frequency is displayed during selection. · Push [FUNC] + [Y] to indicate programmed scan edge for programming other scan edges. Repeat r, y ­ o. t When full or band scan is selected, push [V/M] to exit set mode. When a programmed scan is selected, continue with the following steps to select the band edge frequencies. Full scan Programmed scan 0 (Scan edge channels 198 and 199) 17 6 SCAN OPERATION s Skip channel setting Memory channels can be set to be skipped for memory skip scan. In addition, memory channels can be set to be skipped for both memory skip scan and frequency skip scan. These are useful to speedup the scan interval. w Rotate [DIAL] to select memory channel to be programmed as a skip channel. r Rotate [DIAL] until "SKIP" appears. · Turn the expanded set mode ON for selection. 28) · "SKIP" disappears after 1 sec. and "Sk" appears. s Scan resume condition D Setting the scan pause time The scan pauses when receiving signals according to the scan pause time. It can be selected as a pause or timer scan. w Rotate [DIAL] until "PAUSE" appears. · Turn the expanded set mode ON for selection. [. . . ] Frequency cannot be set. · The lock function is activated. · Channel indication mode is selected. · RIT function is activated. · Push [FUNC] + [(CALL)LOCK] to cancel the function. · Turn the channel indication mode OFF in set mode. [. . . ]