User manual ICOM IC-471H

[. . . ] CAUTION NOTE Equipment damage may occur. No risk of personal injury, fire or electric shock. NEVER short the terminals of the battery pack. DO NOT push [PTT] when not actually desiring to transmit. AVOID using or placing the transceiver in direct sunlight or in areas with temperatures below ­30°C or above +60°C. The basic operations, transmission and reception of the transceiver are guaranteed within the specified operating temperature range. However, the LCD display may not be operate correctly, or show an indication in the case of long hours of operation, or after being placed in extremely cold areas. Icom, Icom Inc. [. . . ] q Push (Scan Mode) several times to select the open scan. Appears 5 Open scan is selected. w Push (Scan) to start the open scan. Blinks r Rotate [VOL] to turn the power OFF, or push and hold [Top] (Set Mode) for 2 sec. to exit set mode. Scan start channel t When receiving a signal, scan pauses and resumes according to the selected scan resume condition. 19 5 SCAN OPERATION I Group and priority scans Group and priority scans repeatedly watch a priority channel while scanning specified channels. This is useful when waiting for a call on the priority channel or several specified channels. Group and priority scans behave differently when transmitting. Group scan can only transmit on a busy channel, and priority scan can only transmit on a priority channel or start channel. q Push (Scan Mode) several times to select the group or priority scan. 18) ·" " appears when the group scan is selected, and " pears when the priority scan is selected. Appears " apPriority channel e Push (Scan) to start the scan. 177. 3 179. 9 183. 5 186. 2 189. 9 192. 8 196. 6 199. 5 203. 5 206. 5 210. 7 No. 45 46 47 48 49 50 51 DSetting CTCSS tone frequency/ DTCS code [ (Hz) Freq. 218. 1 225. 7 229. 1 233. 6 241. 8 250. 3 254. 1 q Select the desired channel except for channels 5 and 35. 11) w Push and hold [Top] (Set Mode) for 2 sec. e Push [Top] several times until "C" appears. r Push to toggle the CTCSS tone frequency/DTCS code setting mode. t Push [CH Up] or [CH Down] to set the desired CTCSS tone frequency/DTCS code. NOTE: The transceiver has 51 tone frequencies and consequently their spacing is narrow compared with units having 38 tones. Therefore, some tone frequencies may receive interference from adjacent tone frequencies. 22 TONE SQUELCH OPERATION 6 · Available DTCS code list No. 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 Code 023 025 026 031 032 036 043 047 051 053 054 065 071 072 073 074 114 115 116 122 125 No. 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 Code 131 132 134 143 145 152 155 156 162 165 172 174 205 212 223 225 226 243 244 245 246 No. [. . . ] An AC adapter should be purchased separately. ·BC-160 DESKTOP CHARGER + BC-145V AC ADAPTER For rapid charging of battery packs. An AC adapter is supplied with the charger. 3 hours when BP-232N is attached. 12 13 47 13 OPTIONS D OTHER OPTIONS · SP-13 EARPHONE Provides clear receive audio in noisy environment. [. . . ]