User manual ICOM IC-4GA

[. . . ] This connection will ruin the transceiver. NEVER cut the DC power cable between the DC plug and fuse holder. If an incorrect connection is made after cutting, the transceiver might be damaged. NEVER place the transceiver where normal operation of the vehicle may be hindered or where it could cause bodily injury. SAVE THIS INSTRUCTION MANUAL -- This instruction manual contains important operating instructions for the IC-4GA and IC-F6062 VHF/UHF MOBILE TRANSCEIVERS. EXPLICIT DEFINITIONS DEFINITION Personal injury, fire hazard or electric shock RWARNING may occur. [. . . ] If the programmable function names are bracketed in the following explanations, the specific key is used to activate the function depends on the programming. CH UP AND DOWN KEYS Push to select an operating channel. Push to select a transmit code channel after pushing [TX Code CH Select]. Push to select a DTMF channel after pushing [DTMF Autodial]. Push to select a scan group after pushing and holding [Scan A Start/Stop]/[Scan B Start/Stop] for 1 sec. ZONE KEY Push this key, then select the desired zone using [CH Up]/ [CH Down]. What is "zone"?--The desired channels are assigned into a zone according to the intended use for grouping. For example, `Staff A' and `Staff B' are assigned into a "Business" zone, and `John' and `Cindy' are assigned into a "Private" zone. 3 Push this key while scan is paused (a signal is detected) on a channel (except for priority channel, ) the channel is cleared from the scan group. Depending on the setting, the cleared channel is added to the scan group again after the scan is cancelled. PANEL DESCRIPTION PRIO A/B KEYS Push to select Priority A or Priority B channel. Push and hold [Prio A (Rewrite)] or [Prio B (Rewrite)] to set the operating channel as the Priority A or Priority B channel. When [Emergency Single (Silent)] or [Emergency Repeat (Silent)] is pushed, an emergency call is transmitted with no beep emission and LCD indication change. · If you want to cancel the emergency call, push (or push and hold) the key again before transmitting the call. · The emergency call is transmitted one time only or repeatedly until receiving a control code depending on the pre-setting. WIDE/NARROW KEY Push to toggle the IF bandwidth between wide and narrow. · The wide passband width can be selected from 25. 0 or 20. 0 kHz using the CS-F5060 CLONING SOFTWARE. (PMR or BIIS PMR operation only) Ask your dealer for details. DTMF AUTODIAL KEY Push to enter the DTMF channel selection mode. Then select the desired DTMF channel using [CH Up]/[CH Down]. After selecting the DTMF channel, push again to transmit the selected DTMF code. RE-DIAL KEY Push to transmit the last-transmitted DTMF code. · TX memories are cleared after turning the transceiver OFF. SURVEILLANCE KEY Push to turn the surveillance function ON or OFF. NON-ZONE TYPE: Push [CH Up] or [CH Down] to select the desired operating channel, in sequence; or, push one of [MR-CH 1] to [MR-CH 4] keys to select a channel directly. ZONE TYPE: Push [Zone] then push [CH Up] or [CH Down] to select the desired zone. AUTOMATIC SCAN TYPE: Channel setting is not necessary for this type. When turning power ON, the transceiver automatically starts scanning. Scanning stops when receiving a call. I Turning power ON q Push [ ] to turn the power ON. [. . . ] w D-Sub 25-pin Connect an external unit. e EXTERNAL SPEAKER JACK Connect a 4­8 external speaker. Optional speaker Microphone q e t w r y DC POWER RECEPTACLE Connects to a 12 V DC battery. Red Black y NOTE: Use the terminals as shown below for the cable connections. Crimp Solder r MICROPHONE HANGER Connect the supplied microphone hanger to the vehicle's ground for microphone on/off hook functions. [. . . ]