User manual ICOM IC-F15S

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ICOM IC-F15S. We hope that this ICOM IC-F15S user guide will be useful to you.

Lastmanuals help download the user guide ICOM IC-F15S.


Mode d'emploi ICOM IC-F15S
Download

You may also download the following manuals related to this product:

   ICOM IC-F15S BROCHURE (2435 ko)

Manual abstract: user guide ICOM IC-F15S

Detailed instructions for use are in the User's Guide.

[. . . ] INSTRUCTION MANUAL VHF TRANSCEIVER iF15/S UHF TRANSCEIVER iF25/S FOREWORD READ ALL INSTRUCTIONS carefully and completely before using the transceiver. PRECAUTION R WARNING!NEVER hold the transceiver so that the antenna is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm away from the lips and the transceiver is vertical. NEVER operate the transceiver with a headset or other audio accessories at high volume levels. [. . . ] NOTE: The memory channels 3 and 4 are available for ICF15S/F25S when [MR-CH 3] and [MR-CH 4] keys are assigned. · TX: Turns Red while transmitting a signal. R · RX: Turns Green while receiving a signal. G · Call LED (ON): When receiving a matched 2/5-tone. OO · Call LED (Blink): When receiving a matched 2/5-tone. O O · Fast/Slow scan: Blinks while Fast/Slow scan is activated. G G · Low BATT1: You should charge the battery. (blinks slowly) G G · Low BATT2: You must charge the battery. (blinks fast) G G G G · TX low BATT2: Low BATT2 was detected during TX mode. R R R R · CH err: Non-programmed channel is selected. RORORORORORORORO 8 9 2 PANEL DESCRIPTION PANEL DESCRIPTION 2 2 MONITOR KEY Mute and release the CTCSS (DTCS) or 2-tone squelch mute. Open any squelch/deactivate any mute while pushing this key. (LMR operation only) Activates one of (or two of) the following functions on each channel independently: (PMR operation only) · Push and hold to un-mute the channel (audio is emitted; `Audible' condition). · Push to mute the channel (sets to `Inaudible' only). · Push to un-mute the channel (sets to `Audible' only). · Push after the communication is finished to send a `reset code'. DTMF AUTODIAL KEY Push to transmit the programmed DTMF code. CALL KEYS Push to transmit a 2/5-tone code. · Call transmission is necessary before you call another station depending on your signalling system. · [Call A] and/or [Call B] keys may be available when your system employs selective `Individual/Group' calls. Ask your dealer which call is assigned to each key. NOTE: The un-mute condition (`Audible' condition) may automatically return to the mute condition (`Inaudible` condition) after a specified period. LOCK KEY Push and hold to electronically lock all programmable keys except the following: [Call] (incl. Call A and Call B), [Moni(Audi)] and [Emergency] keys. OUTPUT POWER SELECTION KEY Select the transmit output power temporarily or permanently, depending on the pre-setting. · Ask your dealer for the output power level for each selection. EMERGENCY KEYS Push and hold to transmit an emergency call. When [Emergency Single (Silent)] or [Emergency Repeat (Silent)] is pushed, an emergency call is transmitted without a beep emission. · If you want to cancel the emergency call, push (or push and hold) the key again before transmitting the call. · The emergency call is transmitted one time only or repeatedly until receiving a control code depending on the pre-setting. VOICE SCRAMBLER FUNCTION KEYS Push to turn the voice scrambler function OFF. Push and hold to turn the voice scrambler function ON. OPT OUT KEYS Push to inactivate the connected output signal level. Push and hold to activate the connected output signal level. This function can be used for situations other than an emergency alert such as a security alarm for example. TALK AROUND KEY Push to turn the talk around function OFF. 2 for antenna attachment. D Transmitting notes · Transmit inhibit function The transceiver has several inhibit functions which restrict transmission under the following conditions: - The channel is in mute condition. - Un-matched (or matched) CTCSS is received. [. . . ] · BP-232 Li-Ion BATTERY PACK 7. 4 V/2000 mAh Li-Ion battery pack, allows approx. *Typical operation; Tx:Rx:Stand-by duty cycle=5:5:90 · MB-93 SWIVEL BELT CLIP · MB-94 BELT CLIP Exclusive alligator-type belt clip. The same as supplied with the transceiver. · MB-96*/96F LEATHER BELT HANGER *MB-93's base clip is required. D DC CABLES · CP-17L CIGARETTE LIGHTER CABLE Allows charging of the battery pack through a 12 V cigarette lighter socket. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ICOM IC-F15S

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ICOM IC-F15S will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag