User manual ICOM IC-F621-1

[. . . ] WORD NEVER allow children to touch the transceiver. NEVER expose the transceiver to rain, snow or any liquids. Other microphones have different pin assignments and may damage the transceiver. Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan) in the United states, the United Kingdom, Germany, France, Spain, Russia and/or other countries. [. . . ] NOTE: The above functions depend on pre-programming. 1 r RIGHT UP/DOWN [ ]/[ ] KEYS Push to select the operating system. Push [ ] key to send the most recently transmitted DTMF code number during transmitting. t DEALER-PROGRAMMABLE KEYS [P0] to [P4] Desired functions can be programmed independently by your dealer. PANEL DESCRIPTION y POWER SWITCH [POWER] Push to turn the power ON and OFF. · At power ON, a power-up alert tone sounds for about 1 sec. And the transceiver automatically starts scanning if the scan function had been activated before the power was turned OFF. 1 I Function display qw e r t y u i o u MICROPHONE CONNECTOR Connect the supplied microphone or optional DTMF microphone. NEVER connect non-specified microphones. The pin assignments may be different and the transceiver may be damaged. D MICROPHONE The supplied microphone has a PTT switch and a hanger hook. q TRANSMIT INDICATOR Appears while transmitting. w BUSY INDICATOR Appears while the channel is busy. e SIGNAL STRENGTH INDICATOR Indicates relative signal strength level. Does not appear when the transceiver is out of the service area when operating on the PassPort system. r LOW POWER INDICATOR Appears when low output power is selected. t MONITOR SWITCH INDICATOR Appears when the monitor switch is pushed. y BELL INDICATOR Blinks when the individual call is received. u PHONE INDICATOR Appears when the phone channel is selected. i SCAN INDICATOR Appears when the scan function is set in the channel, and blinks while scanning. o ALPHANUMERIC DISPLAY Displays an operating channel text, talk group text, etc. 2 2 CONNECTION AND MAINTENANCE I Rear panel and connection Optional speaker (SP-22) q Antenna t red: + w r Optional cable (OPC-617) e black: Supplied DC power cable 12V Battery NEVER connect to a 24 V battery. Crimp Note: Use the terminals for the cable connections. Solder 3 CONNECTION AND MAINTENANCE q MICROPHONE HANGER Connect the supplied microphone hanger to the vehicle's ground. w ANTENNA CONNECTOR Connects to an antenna. Ask your dealer about antenna selection and placement. e DC POWER RECEPTACLE Connects to a 12 V DC battery. [. . . ] IC-F620: The transmitter antenna is required to be located outside of a vehicle and kept at a separation distance of 37 centimeters or more between the transmitter antenna of this device and persons during operation. IC-F621: The transmitter antenna is required to be located outside of a vehicle and kept at a separation distance of 50 centimeters or more between the transmitter antenna of this device and persons during operation. 3 To ensure that your exposure to RF electromagnetic energy is within the FCC allowable limits for occupational use, always adhere to the following guidelines: C AU TIO N · DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed FCC RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio. · DO NOT transmit for more than 50% of total radio use time ("50% duty cycle"). [. . . ]