User manual ICX GLOBAL ARC SA 41

[. . . ] The following sections will help you program your remote to control your other entertainment components. 5 SmartScanTM Automatic Programming 3 Test the code by trying various functions. If the primary function keys fail to respond satisfactorily try the next code listed for the manufacturer. If you have tried all the codes listed for the manufacturer and the device does not respond, try to program the device using SmartScanTM as described in section 5. Remember to record your device codes in section 11 when you are done. SmartScanTM will allow you to easily try all the available programming codes for the selected device and find the best match. [. . . ] To return volume control to the default state: 1 5 Press and release the POWER key. The device key will stop flashing and remain on. 6 Point the remote control at the selected device. 7 Press and hold the UP ARROW key until the device turns off. While holding the UP ARROW key the remote will send a new code approximately once every second. The device button will blink each time a new code is sent. If you pass the code that turns off the device, press the DOWN ARROW key to return to the previous code. Press and hold the CBL device key until all the device keys begin to flash. Press and release the VOLUME DOWN key, and then press and release the SEL key. After you release the SEL key, the CBL device key will flash three times and turn off. 2 Press and release the VOLUME UP key. The CBL device key will stop flashing and stay 8 Master Power Control 8 When the device turns off, you have found a candidate code. Press the POWER key to turn device back on. Test various functions using the remote control to determine if this code will work. If primary functions do not work, make sure the device is still on then resume SmartScanTM by pressing the UP ARROW key to find another device code. The Master Power function allows you to turn off and on two or more devices simultaneously with a single press of the power button. The following steps describe how to program the Master Power Control function: 1 Press and hold the CBL device key until all the device keys begin to flash. The CBL key will continue to flash. 9 Once you have found a satisfactory code, press SEL to lock the code. The device key will then flash three times. Go to section 10 to recall and record your device codes. When all the codes have been attempted the device button will flash rapidly. 2 Press and release the POWER key. 3 Individually press and release each device key corresponding to the components you wish to be controlled by Master Power (starting with the cable device key). NOTE: If no keys are pressed in this step, no change will occur in Master Power programming. 6 Manual Programming 4 Press and release the POWER key. [. . . ] The CBL key will continue to flash. 2 Press and release the CHANNEL UP key. 3 Press and release the CHANNEL DOWN key. The CBL device key will flash three times to confirm the procedure. 5 Repeat these steps to reactivate Channel Lock. 10 Recalling A Device Code Use the following steps to read the code set for a device. This is useful for determining a device code that was set using the SmartScanTM procedure described in section 5. 1 Press and hold the device key to be read until all device keys begin to flash (approximately 3 seconds). [. . . ]