User manual IDEAL 61320

[. . . ] Ensure meter is in proper working order before using. Performing a continuity check can verify proper operation. If the meter reading goes from overload to zero, this typically means the meter is in proper working order. Visually inspect leads for damage before using. [. . . ] Measure AC Voltage. 6 DC Volts Circuit Connection: Range 600mV 6V 60V 600V 1000V Resolution 100µV 1mV 10mV 100mV 1V Max. Display 600. 0 ±(0. 5% reading 6. 000 + 2 digits) 60. 00 600. 0 1000 Accuracy Input Impedance: 10M (over 1000M in 600mV range) To Measure DC Voltage: 1. Plug the black test lead into the COM port and the red test lead into the Hz V µA port. Set the rotary switch to the v position. Connect the meter in parallel with the load or circuit. Measure DC Voltage 7 DC Current Circuit Connection: Range Resolution 600µA 6000µA 0. 1µA 1µA Voltage Max Burden ±(1. 0% reading < 4mV / µA 600. 0 + 2 digits) 6. 000 Accuracy Overload Protection: µA input: 600V RMS To Measure DC Current: 1. Plug the black test lead into the COM port and the red test lead into the Hz V µA port. Set the rotary switch to the mA or A position. Connect the meter in series with the load or circuit. Measure DC Current. 8 Frequency/RPM Circuit Connection: Range 6000Hz 60KHz 600KHz 6MHz 60MHz Resolution 1Hz 10Hz 100Hz 1KHz 10KHz Sensitivity 100mV RMS Accuracy Frequency: 0. 01% ±1 digit 250mV RMS 1V RMS Overload Protection: 600V rms *Less than 20Hz the sensitivity is 1. 5V To Measure Frequency: 1. Plug the black test lead into the COM port and the red test lead into the Hz V µA port. Set the rotary switch to the Hz position. Connect the meter in parallel with the load or circuit. Measure Frequency. 9 Resistance (Ohms) Circuit Connection: Range 600 6K 60K 600K 6M 60M Resolution Accuracy Max. Display 0. 1 600. 0 1 ±(0. 7% reading 6. 000 10 + 2 digits) 60. 00 100 600. 0 1K 6. 000 10K 60. 00 Open Circuit Voltage: -1. 3V approx. Turn the power off to the circuit or device that is to be measured and discharge all capacitors before attempting a measurement. Plug the black test lead into the COM port and the red test lead into the Hz V µA port. For correct reading, ensure that the device being tested contains no voltage. Connect test leads across the resistor or circuit to be measured. 10 Multiplication Guide for Ohms (): 400 = Meter indicates actual resistance 4k = Multiply meter display reading by 1, 000 to acquire actual resistance. 40k = Multiply meter display reading by 1, 000 to acquire actual resistance. 400k = Multiply meter display reading by 1, 000 to acquire actual resistance. [. . . ] Remove the screw from the battery cover and lift to remove. Remove the screws from the bottom case and the inside of the battery cover and lift the case bottom until it unsnaps from the case top. Remove the defective fuse by gently prying one end of the fuse loose and sliding the fuse out of the fuse holder. Install a new fuse of the same size and rating. [. . . ]