User manual IIYAMA PROLITE B2780HSU

[. . . ] The electro-magnetic susceptibility has been chosen at a level that gives correct operation in residential areas, business and light industrial premises and small-scale enterprises, inside as well as outside of the buildings. All places of operation are characterised by their connection to the public low voltage power supply system. Com You can access the Web page of different countries from there. All trademarks used in this user manual are the property of their respective owners. [. . . ] Lay the monitor flat on a table with front face down. B Pull the knob upwards, then unfix the screw and remove the Stand-Base. Keyhole for Security Lock NOTE You can fasten a security lock and cable to prevent the monitor from being removed without your permission. Keyhole for Security Lock NOTE You can fasten a security lock and cable to prevent the monitor from being removed without your permission. Ensure that both the computer and the monitor are switched off. connect the computer to the monitor with the signal cable. Connect the AC Adapter to the monitor and the Power Cable to the AC Adapter first and then connect to the power supply. NOTE The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. the cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office. NOTE Do not touch the LCD screen when you change the angle. It may cause damage or break the LCD screen. Careful attention is required not to catch your fingers or hands when you change the angle. Do not tilt the post beyond 20 degrees except when repacking the monitor in its box. For optimal viewing it is recommended to position yourself directly opposite to the full face of the monitor, then adjust the monitor's height and angle to your own preference. Hold the panel so that the monitor does not topple when you change the monitor's height or angle. You are able to adjust the monitor's height up to degrees upward, 5° downward. NOTE Do not touch the LCD screen when you change the height or the angle. It may cause damage or break the LCD screen. Careful attention is required not to catch your fingers or hands when you change the height or the angle. Injury can occur if care is not taken to avoid finger contact with the displays base when adjusting the height. [. . . ] In case the strong flicker or blurs remain on a part of the screen, repeat steps because the Pixel Clock may not be adjusted correctly. Position after the Phase adjustment if the horizontal position moves during the adjustment. Adjust the Brightness and Color to get the desired picture after you complete the Pixel Clock and Phase adjustments. The power management feature of this product complies with power saving requirement of ENERGY STAR® and VESA DPMS. [. . . ]