User manual IKEA TTARE-002.506.64

[. . . ] Safety information Product description Control panel Programmes Options Before first use Daily use Subject to change without notice. Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. [. . . ] The appliance is in setting mode when, after the activation the display shows 2 horizontal status bars. If the control panel shows other conditions, press the cancel button until the appliance is in setting mode. Starting a programme without delay start Press the on/off button to activate the appliance. Make sure that the appliance is in setting mode. The related programme number If you want, you can set the options. If you open the door, the display Shows the programme duration that decreases with steps of 1 minute. Starting a programme with delay start Press the delay button again and again Until the display shows the delay time you want to set (from 1 to 24 hours). If you open the door, the display shows the countdown of the delay start that decreases with steps of 1 hour. When the countdown is completed, the programme starts. Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance continues from the point of interruption. Cancelling the delay start while the countdown operates Press the cancel button until the display shows 2 horizontal status bars. When you cancel a delay start, the appliance goes back to setting mode. Cancelling the programme Press the cancel button until the display shows 2 horizontal status bars. Make sure that there is detergent in the detergent dispenser before you start a new programme. The display shows 0 and the end indicator comes on. Press the on/off button to deactivate the If you do not press the on/off button, the AUTO OFF device automatically deactivates the appliance after some minutes. This helps to decrease the energy consumption. Let the dishes become cold before you remove them from the appliance. First remove the items from the lower basket, then from the upper basket. There can be water on the sides and on the door of the appliance. Hard water contains a high quantity of minerals that can cause damage to the appliance and bad washing results. [. . . ] Unless such damages can be proved to have been caused by production faults. Cases where no fault could be found during a technician's visit. Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. Repairs caused by installation which is faulty or not according to specification. [. . . ]