User manual INDESIT DG6145W

[. . . ] DG 6145 Dishwasher Installation and use Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. - During installation, the power supply cord must not be excessively or dangerously bent or flattened; - If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. 5. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. 6. This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. [. . . ] F). 1 2 Bottom Rack Upper Rack Load for 8 Standard Settings (For IEC tests : top rack at top position) 3 Fig. F 4 5 GB Turning on the Appliance Starting a wash cycle. . . . Make sure that the plug for the appliance is inserted into the wall socket. Make sure that the water supply is turned on to full pressure. Load the dishwasher (see the section entitled, "Loading the Dishwasher"). Pour in the detergent (see the section entitled, "Salt, Detergent and Rinse Aid"). Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table"). Press the ON-OFF botton, and the ON-OFF light will turn on. At this point, the wash cycle will begin. Cancelling or modifying a wash cycle setting. . . Premise: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). 1 4 2 If you forget to load some of the dishes. . . The wash cycle can be interrupted by pressing the ON-OFF button. You can then load additional dishes and turn the appliance back on. When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. 3 STOP Press the ON-OFF button, and the ON light will turn off. Rotate the knob in the clockwise direction to the desired cycle setting (see the section entitled, "Starting a wash cycle. . . "). Then, turn the dishwasher back on using the ONOFF button. GB 6 Wash Cycle Table Cycle Cycle Selection Information Very dirty dishes, pots and pans (not to be used with delicate items). Description of Cycle Detergent Rinse Aid 1) Heavy Duty Pre-wash with hot water (45°C). Drying. 20 gr. * 2) Normal Wash (IEC-EN 50242) Normally dirty dishes, pots and pans. Standard daily cycle. Pre-wash with cold water. Drying. 20 gr. * 3) Rapid Wash Economic, fast cycle to be used to on not very dirty dishes right after they are used. [. . . ] In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter of 4 cm. , or let it run into the sink, making sure to avoid bending or crimping it. Use the speical plastic support that comes with the appliance (see figure to the right). [. . . ]