User manual INDESIT DI 620

[. . . ] NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC (Low Voltage) and subsequent modifications; - 89/336/EEC (Electromagnetic Compatibility) and subsequent modifications. After removing the packing, check to make sure that the appliance is not damaged. The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. [. . . ] Premise: A cycle that is underway can only be modified if it has only been running for a short time. Open the appliance door carefully to avoid any hot water splashes, then keep button "P" pressed for approximately 5 seconds, until you hear 3 short beeps. Indicator light "C" will come off and at this point, all the settings will have been cancelled. You are now free to re-set the correct wash cycle. If you forget to load some of the dishes. Interrupt the wash cycle by opening the appliance door with the utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it. The wash cycle stops and then restarts when the electricity comes back on or when you close the door. The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "C". Open the dishwasher door, turn off by pressing button "A", unplug the appliance from the electricity socket to cut off the power supply; the power supply cable should consequently be easily accessible. Wait a few minutes before unloading the dishes: they are very hot!If you wait a little while, they dry better thanks to the steam. Make sure the wash cycle has ended before removing the dishes!Warning If opening the door soon after the end of the programme, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Very dirty dishes, pots and pans (not to be used with delicate items). 2 Rinses with cold water Rinse with hot water at 70°C. Rinse with cold water Rinse with hot water at 70°C. Pre-wash of dishes, pots and pans while waiting for the load to be completed after the subsequent meal. Short cold wash to prevent food residue from drying on the dishes. Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. [. . . ] Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Cold Water Connection This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. In the event of replacements, use original spare parts only. Connect the cold water supply hose to a 3/4 gas threaded connection, taking care to screw it tightly onto the tap. [. . . ]