User manual INDESIT DI62

[. . . ] Dishwasher Instruction for installation and use DI 62 Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications. 1. Carefully dispose of the packing material. 2. After removing the packing, check to make sure that the appliance is not damaged. [. . . ] Close the appliance door and after a few seconds, you will hear a short beep: the wash cycle has begun. Canceling or changing a cycle while it is underway . . . Premise: You can modify the wash cycle in progress, if it has only just started. Open the appliance door carefully to avoid any hot water splashes, then keep button "P" pressed for approximately 5 seconds, until you hear 3 short beeps. Indicator light "C" will come off and at this point, all the settings will have been cancelled. You are now free to re-set the correct wash cycle. The wash cycle can be interrupted by opening the door carefully (to prevent sprays of hot water and hot steam). Put the dishes into the dishwasher and close the door. The appliance will start up where it left off. The wash cycle stops and then restarts when the electricity comes back on or when you close the door. The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "C". Open the dishwasher door, press the ON-OFF button as well, thus cutting off the electricity supply to the appliance. Wait a few minutes before unloading the dishes: they are very hot!If you wait a little while, they dry better thanks to the steam. If opening the door soon after the end of the programme, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. 5 GB Wash Cycle Table Cycle Cycle selection instructions Cycle description Detergent for prewash + wash Rinse Aid 1) Heavy Duty Very dirty dishes and pans (not to be used for delicate items). Pre-wash with cold water Pre-wash with hot water at 45°C Extended wash at 70°C. Cold rinse Rinse with hot water at 70°C. Drying. 5+25 gr. * 2) Normal wash Normally dirty pans and dishes. Standard daily cycle. 2 pre-washes with cold water. Drying. 5+25 gr. * 3) Rapid Economic and fast cycle to be used for slightly dirty dishes. Cold rinse. 25 gr. 4) Soak Preliminary wash cycle for dishes and pans awaiting completion of the load with the dishes from the next meal. Short cold wash to prevent food from drying onto the dishes. GB 6 Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. [. . . ] Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter of 4 cm. , or let it run into the sink, making sure to avoid bending or crimping it. Use the speical plastic support that comes with the appliance (see figure to the right). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. Attention: The special plastic hose support must be solidly fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain. [. . . ]