User manual INDESIT FIMDE23IX

[. . . ] That the inlet and draining pipes are connected correctly. Never use hoses that have already been used, always use the new ones provided with your machine; 3. That the washing machine is levelled properly; something worth checking to aid the performance of your washing machine; 4. That the drum's fixing screws have been removed from the back of the washing machine. 2. [. . . ] The washing machine fails to start. Is the plug correctly inserted into the socket?It could have been moved whilst cleaning. A circuit breaker may have switched off as a result of too many electrical appliances working at the same time. Or maybe due to a general failure in your entire area. Is the washing machine door closed properly?For safety reasons, the washing machine cannot work if the door is open or not shut properly. If it is, then a programmed start has been set. Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. But where did all the water go? Simple: with the new Indesit technology, you need less than half of it, to get good results on twice as much!Make sure the drain hose is not squashed or kinked. Is the washing machine's drain duct clogged?Is there an extension of the drain hose?If so, is it positioned incorrectly, blocking the water flow? Is there space between the machine and adjacent units?If it is not a built-in model, the washing machine will oscillate a bit during the spin cycle. A few cm of space should therefore be left around it. The washing machine does not drain or spin. Does the selected programme incorporates water draining?Some programmes stop at the end of the wash cycles and draining will have to be selected manually. Is the "Easy iron" function -where provided - enabled?This function requires manual selection for draining. To check it, turn off the water supply, unplug the washing machine and follow the instructions on page 12, or call for technical assistance. Too much foam. Is the detergent appropriate for machine washing?Check whether the definition on its label reads "for machine wash" or "hand and machine wash", or any other similar wording. [. . . ] The power supply cable must never be bent or dangerously compressed. I only want an authorised specialised technician with original Indesit spare parts! Your washer has been built in compliance with the strictest international safety regulations. Never pull on the supply cable or the washing machine to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high temperatures. The appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. [. . . ]