User manual INDESIT IDVA 835

[. . . ] Instruction manual TUMBLE DRYER Contents EN English, 1 F Français, 17 NL Nederlands, 33 Installation, 2-3 EN Where to install the tumble dryer Ventilation Electrical connections Levelling the tumble dryer Before you start your dryer DE Deutsch, 49 Description of the tumble dryer, 4-5 Front side Rear side Control panel How to carry out a drying cycle, 6 Starting and selecting a programme Programme chart Special programmes Options Opening the door Sorting laundry Care labels Special items Drying times Programmes and options, 7-8-9 IDVA 835 Laundry, 10-11 Warnings and suggestions, 12 General safety Information on recycling and disposal Saving energy and respecting the environment Care and maintenance, 13 Disconnecting the power supply Cleaning the filter after each cycle Checking the drum after each cycle Cleaning the tumble dryer   This symbol reminds you to read this instruction Keep this manual at hand for immediate reference manual. Always store this manual close to the tumble dryer and remember to pass it on to any new owners when selling or transferring the appliance, so they may familiarise with the warnings and suggestions herein contained. Troubleshooting, 14 Assistance, 15 Spare parts  Read these instructions carefully: the following pages contain important information on installation and useful suggestions for operating the appliance. 1 Installation EN Where to install the tumble dryer • Install the dryer far from gas ranges, stoves, radiators or hobs, as flames may damage it. [. . . ] It is necessary to press the START/PAUSE button to resume the “Delay start” programme. One of the “Delay start” indicator light flashes to signal the delay time entered. • It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running phase and the START/PAUSE indicator light stops flashing and turns green. • During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from the beginning. • By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This procedure can be used to select the Cold drying programme to cool garments if they are judged to be dry enough. Press the START/PAUSE button to start the new programme. Note: In the event of a power cut, turn the power switch off and remove the plug; when the electricity supply returns, press the START/PAUSE button to resume the programme. 9 Laundry EN Sorting laundry • Check the symbols on the care labels of the various garments to verify whether the garments can be safely tumble dried. • Sort laundry according to the type of fabric. • Wring out garments to remove the maximum amount of water possible. Care labels Always check the care labels, especially when placing garments in the tumble dryer for the first time. Below are the most commonly used symbols: May be tumble dried.  Do not load the dryer when garments are dripping wet. Maximum load sizes Do not overload the drum. The following values indicate the weight of dry garments: Natural fibres: maximum 7, 5 kg Synthetic fibres: maximum 3 kg  Do not overload the dryer as this may result is reduced drying performance. Typical weights Note: 1 kg = 1000 g Garments Blouse Dress Jeans 10 Nappie Shirt T-shirt Household linen Duvet cover (double bed) Large tablecloth Small tablecloth Tea cloth Bath towel Hand towel Double bed sheet Single bed sheet Cotton Other 1, 500 g 1, 000 g 700 g 250 g 100 g 700 g 350 g 500 g 350 g Cotton Other Cotton Other Cotton Other 150 100 500 350 g g g g Items not suitable for tumble drying: • Items containing rubber parts or similar materials, or plastic film covering (pillows, cushions or PVC sports jackets), any type of inflammable object or objects containing inflammable substances (used towels containing hairspray). Glass fibres (certain types of draperies). • Items which have been previously dry cleaned. • Items marked with the ITLC symbol (“Special garments”) , which may be washed using special household products. [. . . ] If an automatic programme has not detected the final dampness level required in this interval, the dryer completes the programme and stops. Check the above points and repeat the programme; if the items are still damp, contact the Technical Assistance Centre (see Assistance). The “Options” and “START/ PAUSE” indicator lights flash and one of the “Maintenance” or “Drying phases” indicator lights turns on without flashing. The dryer is noisy during the first few minutes of operation. [. . . ]